1.
Analysis on temperature field in electrofusion joint for polyethylene pipes
聚乙烯管道电熔接头焊接过程温度场分析
2.
Finite Element Analysis and Structure Optimization of the Flange Welding Jonits;
法兰电熔接头的有限元分析和优化设计
3.
Ultrasonic Testing and Safety Assessment of Defects in Electro-fusion Joint of Polyethylene Fuel Gas Pipe;
聚乙烯燃气管道电熔接头缺陷的超声检测及安全评定
4.
Investigation on the Imaging Law of Metal wire in Electrofusion Joint by Phased Array Ultrasonic Technique
聚乙烯电熔接头中金属丝成像规律的理论分析与试验研究
5.
Analyse on the Influences of the Irregular Surface of Electro-fusion Joint When Tested by Phased Array Ultrasonic Technique
聚乙烯电熔接头表面不规则对超声相控阵检测的影响分析
6.
Repair connector terminal or wire splice.
维修接头端子或电线熔接处。
7.
Broken connector terminal or wire splice in fog lamp circuit.
雾灯电路的接头端子或电线熔接处断裂。
8.
CHECK THE FUSE THAT SUPPLIES POWER TO THE FUSED IGNITION SWITCH OUTPUT CIRCUIT AT TRS CONN.
检查给ＴＲＳ接头的熔断点火开关输出电路供电的熔丝。
9.
USING A VOLTMETER MEASURE FUSED IGN SW OUTPUT CKT AT THE RED CONN.
用伏特表测量红色接头处的熔断点火装置开关输出电路。
10.
The ESR process consists of three stages: 1) Formation of dropets on the electrode tip;
电渣重熔有三个阶段:1.电极端头熔滴形成期;
11.
Welding parameter.( Reference values for electric socket welding-welding time and cooling time.
熔接参数(考数值为电承插热熔，热熔时间和冷却时间.
12.
Methods for radiographic inspection and classification of radiographs for fusion welded butt joints in steel
GB/T3323-1987钢熔化焊对接接头射线照相和质量分级
13.
All full-penetration joints shall be back purged with argon or helium.
所有全熔透焊接接头用氩或氦进行反吹。
14.
Damage Behavior of Welded Joints with Defects on Fusion Line;
熔合线含缺陷焊接接头损伤行为的研究
15.
Numerical Simulation on Residual Stress Fields and Temperature Fields of Weld Joint in the Process of Fusion Welding
熔化焊焊接接头的温度场和应力数值模拟
16.
Influence of laser melting on microstructure and properties of 1Cr18Ni9Ti welding joint
激光熔凝对1Cr18Ni9Ti焊接接头组织和性能的影响
17.
The supersonic detection of full penetration T-typed and corner joint of steel structure
钢结构全熔透T型及角接接头的超声波检测
18.
The end of the wire had become accidentally fused with the switch, and was dangerous.
电线头偶然同开关熔在一起了，很危险。