1.
Research of Function Block Adapter based on UML Modeling
基于UML建模的功能块适配器研究
2.
You must configure at least one network adapter before the computer can be promoted.
必须至少配置一块网络适配器，才能提升计算机。
3.
An intelligent adapter can off-load CPU-intensive functions from the host protocol stack to the adapter hardware.
智能化的适配器能够把CPU处理密集的功能从主机协议栈下放到适配器硬件上。
4.
high-speed adapter teleprinter module
高速适配器电传打印机模块
5.
amplifier block
放大器功能块，放大器组件
6.
Assemble module adaptor hand tight to bottom half.
安装模块适配器，用手将其紧固在下半部地方。
7.
To run this wizard at least one network adapter must be enabled. Enable an adapter in Network Connections and then rerun the wizard.
必须至少启用一块网络适配器才能运行此向导。请在网络连接中启用适配器，然后重新运行此向导。
8.
Adaptive predistortion for power amplifiers based on block-oriented model
模块化模型功率放大器的自适应预失真
9.
Failed to assign command '{0}' to adapter because its parent is already this adapter
未能将命令“{0}”分配给适配器，因为其父级已是该适配器
10.
Study on V-BLAST OFDM systems with adaptive bit and power allocation
自适应比特功率分配的V-BLASTOFDM系统性能
11.
Development of multi-function var compensation controller for low-voltage distribution transformer
多功能低压配变无功补偿控制器开发
12.
The Design of VXIbus-based Multifunctional Counter Module;
VXI总线多功能计数器模块的研制
13.
The study of a parallel algorithmic method of adaptive ABMA
一种自适应块匹配并行算法的研究及性能分析
14.
Research and Realization of Multi-functional Equipment Module Based on LXI Bus
用于LXI仪器的多功能仪器模块的研究与实现
15.
The Function Modules in the Assembly Design System of Production;
产品装配设计系统中各功能子系统模块
16.
Design and Control of Fast Load Dynamic Response for High Power Adapter
大功率适配器的快速负载动态响应控制与设计
17.
Study and Design of High Power Soft-switching Adpater;
大功率软开关电源适配器的研究与实现
18.
A Power Divider for Dual-Frequency of ISM and Simulation and Verification Based on MWO and Sonnet
一种适用于ISM双频段的功率分配器的设计