1.
Metallic materials - Hardness test tables of Brinell hardness values for use in tests made on flat surfaces
金属材料－－硬度试验－－平面试验用布氏硬度值表
2.
It was found that the surface roughness is significant in Brinell hardness testing, but has little influence on Rockwell hardness.
结果表明,表面粗糙度对布氏硬度值有重要影响,而洛氏硬度值与表面粗糙度关系不大。
3.
Table for Comparison of Tensile Strength and Hardness(Brinell,Rockwell,Vicker)
抗拉强度与硬度(布氏、洛氏、维氏)对照表
4.
Brinell magnifier
布氏硬度测量放大镜
5.
semi-automatic optical Brinell hardness tester
半自动光学布氏硬度计
6.
radial arm Brinell hardness tester
摇臂布氏硬度试验机
7.
Brinell impact hardness tester
锤击式布氏硬度试验机
8.
double impression method
锤击布氏硬度测定法
9.
Mold base to be minimum hardness of165 BHN.
（2） 模座的最低硬度为165布氏硬度。
10.
Mold base to be minimum hardness of 165 BHN.
模座的最低硬度为165布氏硬度。
11.
Evaluation About Uncertainty of the Measurement During Brinell Hardness Test
布氏硬度试验中测量不确定度的评定
12.
Evaluation of the Measurement Uncertainty in Brinell Hardness Test
布氏硬度试验中测量的不确定度评定
13.
Metallic materials Hardness test Tables of Vickers hardness values for use in tests made on flat surfaces
金属材料－－硬度试验－－平面试验用维氏硬度值表
14.
Calibration of standardized blocks to be used for Brinell hardness
GB/T6270-1997标准布氏硬度块的标定
15.
Metallic materials--Brinell hardness test
GB/T231-1984金属布氏硬度试验方法
16.
Cavities and cores must be280 BHN or higher.
（3）公母模仁要在280布氏硬度或更高。
17.
Verification of Brinell hardness testers
GB/T6269-1997布氏硬度计的检验
18.
The Common Maltfunction and Settlement about the Control Mechanism of Brinell′s Hardness Tester
布氏硬度计控制机构常见故障及处理