1)  pressure regulating valve unit
调压阀组
2)  voltage adjustment
调压
3)  pressure adjustment
调压
1.
Based on comprehensive study of air seepage in the workings and pipe flow of ventilation system,a mathematic model for air pressure adjustment in a fire over a great extent to describe completely and accuratily the mechanism and process of air pressure adjustment.
以采场渗流与通风系统的管流进行一体化分析为出发点,建立的大面积火区调压仿真模型从数学上完整、准确地描述了大面积火区调压机理及过程。
4)  Voltage regulating
调压
5)  voltage regulation
调压
1.
Seletion of switch with on-load voltage regulation of 110kV direct step-down rectifying equipment;
110kV直降式整流装置有载调压开关的选择
2.
The voltage regulation action of controlled reactor in distribution network is introduced.
介绍了可控电抗器在配电网中的调压作用 ,它可以有效抑制电网电压的波动 ,改善供电质量。
3.
Then on basis of the binary Trans- former Regulator system, the hardware circuit of the voltage regulation system is given, including the main circuit and the control circuit.
对二进制变压器组稳压系统进行了研究,给出了调压系统硬件电路,包括主电路和控制电路,并进行了软件设计。
6)  voltage regulator
调压
1.
The principle of thyristor voltage regulator was discussed.
阐述了晶闸管调压电路的原理,研究了异步电动机功率因数角随转速变化的规律以及功率因数角的检测方法。
2.
AC chopping voltage regulator is characterized of high performance,now being extensively applicable in small and medium voltage regulation .
交流斩波控制调压技术是一种新型高性能的交流调压技术 ,在中小交流调压领域获得广泛应用。
3.
AC chopping voltage regulator is characterized of high performance, now being extensively applicable in small and medium voltage regulation By comparison of the topologies having been given in reference, this paper gives their advantages and disadvantages , applying occasions respectively Based on the comparison, one of the topology is chosen for a novel water heater .
交流斩波控制调压技术是—种新型高性能的交流调压技术,在中小交流调压领域日益获得广泛应用。
参考词条
补充资料:调压阀噪声控制


调压阀噪声控制
noise control of pressure regulating valve

t旧oyafa zaosheng kongzh-调压阀噪声控制(noise eontrol of pressureregulating valve)使高炉煤气调压阀组和各种调压阀产生的噪声声级在设定范围内的过程,是炼铁噪声控制的重要组成部分口 噪声的产生与特点在炼铁生产的管路系统中装有各种调压阀,其中噪声污染最严重的是煤气调压阀组。煤气调压阀组装在文氏管后,由于通过阀组的气流量大,压降高,产生的噪声声级非常高。在调压阀出口管内,最高噪声声级能达到160一170dB〔A),不仅污染调压阀周围地区,而且还沿管道传播。 基本控制措施主要采取两项措施:(l)对调压阔使用隔声包扎加隔声罩的方法,控制噪声经阀体向外传播;(2)在调压阀出口加装阻性消声器,防止高噪声沿管线传播,同时对消声器壳体进行隔声包扎。采取上述两项措施后,均能获得令人满意的效果,可使调压阀组引起的噪声达到国家控制标准以下 中国使用的高炉煤气调压阀组消声器由冶金工业部建筑研究总院研制,是一种阻性片式消声器,其中吸声片可以更换,当需要更换时,只需拆下盖板、吊出旧吸声片,插人新吸声片即可。消声器壳体外的隔声包扎层中有3层铅板,故成本较高。对于炉容在Z000m“以下的高炉,调压阀组的隔声包扎层断面可采用下图所示结构。 8、7、65一/尸/亩赤拭_49…国肖…. 煤气调压阀组隔声包扎层断面图 1一消声器壳体;2一钢丝网;3一决干水泥;4一铅板;5镀锌 钢板;6一螺母:7一螺栓;8一垫圈;9一岩棉 发展方向采用取消调压阀组的方式来控制炉顶压力,从根本上消除调压阀组噪声。此新工艺已在世界上获得应用 (陆永年)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。