说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 喘振
1)  surge [英][sɜ:dʒ]  [美][sɝdʒ]
喘振
1.
Anti-surge Control of Centrifugal Compressor;
离心式压缩机的防喘振控制
2.
Anti-surge control of air blower for reaction tower;
反应塔送风机的防喘振控制
3.
Approach to the control of anti-surge of compressor sets in nitric acid plant;
硝酸装置压缩机组防喘振控制方法探讨
2)  Surging [英][sə:dʒ]  [美][sɝdʒ]
喘振
1.
The air compressor internal cooler was plugged,leading to bad heat exchanging,temperature raising of the compressor media and compressor bundle surging.
空压机内冷器堵塞,换热效果差,造成压缩介质温度升高,使机组发生喘振
2.
Using the network method of fluids, an operation mode of two shunt connected axial blowers is being calculated as well as the critical angle difference of moving blades, at which surging of the blowers may occur.
该文利用流体网络法 ,计算了并列的两台轴流风机的动态运行情况 ,找出了并列运行两台轴流风机发生喘振的临界动叶角度差。
3)  anti-surge
防喘振
1.
An anti-surge control for centrifugal compressor;
离心压缩机的防喘振控制
2.
The Research of the Anti-surge Fuzzy Control for Compressor;
压缩机防喘振模糊控制研究
3.
Anti-surge Study of Centrifugal Compressor
离心式压缩机防喘振研究
4)  Anti surge
防喘振
1.
A relicable anti surge control system must be erected in order to prevent compressor operation from being close to surge point.
阐述了应用在轴流压缩机的GHHTURBOLOG防喘振控制系统的原理、特点及存在问题的解决方法。
5)  surge curve
喘振曲线
6)  antisurge
防喘振
1.
Design and Application of Antisurge Automatic Control Circuitry for Blower Unit;
鼓风机组防喘振自动控制回路的设计与应用
2.
Analysis of Antisurge Control of the Axial Flow Compressor;
轴流压缩机的防喘振控制分析
3.
Interlock protection control and antisurge system of certain SO_2 blower imported from Germany are introduced and analyzed in this paper.
介绍和分析某一从德国进口的SO_2风机的连锁保护控制、防喘振系统,依据制造商提供的技术资料开发完成了与其配套的控制装置,并增设了本机系统与制酸流程整体连锁保护功能,使得SO_2风机开车生产、连锁停车保护功能更完善。
补充资料:喘振
      流体机械及其管道中介质的周期性振荡,是介质受到周期性吸入和排出的激励作用而发生的机械振动。例如,泵或压缩机运转中可能出现的喘振过程是:流量减小到最小值时出口压力会突然下降,管道内压力反而高于出口压力,于是被输送介质倒流回机内,直到出口压力升高重新向管道输送介质为止;当管道中的压力恢复到原来的压力时,流量再次减少,管道中介质又产生倒流,如此周而复始。喘振的产生与流体机械和管道的特性有关,管道系统的容量越大,则喘振越强,频率越低。流体机械产品一般都附有压力-流量特性曲线,据此可确定喘振点、喘振边界线或喘振区。流体机械的喘振会破坏机器内部介质的流动规律性,产生机械噪声,引起工作部件的强烈振动,加速轴承和密封的损坏。一旦喘振引起管道、机器及其基础共振时,还会造成严重后果。为防止喘振,必须使流体机械在喘振区之外运转。在压缩机中,通常采用最小流量式、流量-转速控制式或流量-压力差控制式防喘振调节系统。当多台机器串联或并联工作时,应有各自的防喘振调节装置。
  

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条