1) extrusion wheel velocity
挤压轮转速
2) Wheel angular velocity
挤压轮速度
3) roller speed
压轮转速
1.
Methods The influence of roller pressure,roller speed,and water content of extract powder on yield and friability of particle diameter was investigated.
方法考察压轮压力、压轮转速和浸膏粉含水量对颗粒得率和颗粒脆碎度的影响。
4) Gear extrusion
齿轮挤压
1.
Stream surface modeling for the gear extrusion mould cavity;
齿轮挤压成形型腔流曲线曲面造型
5) extrusion wheel
挤压轮
1.
It is very difficult to determine precisely the distribution of the stresses in concave-grooveof extrusion wheel．By using the theory of complex function of elastic mechanics，a new calcu-lating method about stresses in concave-groove is presented． The effect of the stresses con-centration which is relevent to the geometric parameters is given.
应用弹性力学的复变函数理论对连续挤压机挤压轮的轮槽应力进行了分析计算，指出了轮槽主要多数对应力集中的影响，这对挤压轮的失效分析和设计具有重要的指导意义。
2.
The causes of extrusion wheel fracture was analyzed by optical direct reading spectrometer,optical microscope and scanning electron microscope(SEM).
利用直读光谱仪、光学显微镜和扫描电镜等检测仪器,分析了挤压轮的材料化学成分、断口形貌以及显微组织情况。
6) turbo-charger speed
涡轮增压器转速
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条