说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 水龙头
1)  swivel [英]['swɪvl]  [美]['swɪvḷ]
水龙头
1.
Swivel packing seal assembly is the key of the swivel, whose function directly influences its service life, further more, and affects the drilling speed.
盘根密封是水龙头的关键环节,其性能直接影响水龙头的寿命和钻井速度。
2.
The wash pipe packing of drilling swivel showed wear-and-tear continually in drilling process due to its structural design.
钻井水龙头由于结构设计的原因,冲管盘根在钻井过程中不断磨损,特别是在高压泥浆的作用下,盘根密封常常被破坏。
3.
The mean value of work loads on a shaft bearing of swivel and rotary table is determined by basic principles of fuzzy theory, considering the loads' fuzziness and the requirement for reliability.
考虑钻机水龙头和转盘主轴承工作载荷的模糊性及可靠性要求,应用模糊数学基本原理求得平均计算载荷,从而计算出主轴承的模糊可靠性寿命。
2)  Tap [英][tæp]  [美][tæp]
水龙头
1.
Effects of Cast Iron and Chromeplate Tap on Over Night Tap Water Quality;
铸铁和镀铬水龙头对过夜自来水水质的影响
2.
Human-computer interaction problem of tap was discussed from the two aspects: switch device design and flowing angle design.
从开关装置设计和出水角度设计两方面探讨了水龙头的人机交互问题。
3)  faucet [英]['fɔ:sɪt]  [美]['fɔsɪt]
水龙头
1.
A design method of the constant temperature faucet based on single chip computer is introduced.
介绍了基于单片机的恒温水龙头的设计方法。
2.
Based on his many years of practical experience,the author pointed out that the appearance quality of faucet plumbing electroplating depends on the 4 aspects: material quality,polishing and grinding,pre-treatment and electroplating process.
结合多年的生产实践经验,认为水暖零件水龙头电镀的外观质量取决于零件材质、抛磨光、前处理和电镀工艺等4个方面。
4)  water cock
水龙头
1.
The water cock is one of the most important composition parts on the drilling machine.
水龙头是钻机的重要组成部件。
5)  water swivel
水龙头
1.
The design of the dual way water swivel is briefly described with the problems encountered in use and corresponding solution
简要介绍了双通道水龙头设计和使用中遇到的问题及相应的解决办法。
6)  Longtou springwater
龙头泉水
补充资料:水龙头
1.自来水管出口上的开关。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条