1) phreatic surface
浸润面
1.
As a common practice,the present slope stability analysis would begin with the determination of phreatic surface,and then the stability would be analyzed.
水库蓄水后将形成大量的涉水边坡,库水水位的变化将对其稳定性产生影响,目前关于这类边坡的稳定性分析,一般都是首先确定坡体内浸润面的位置,然后再进行稳定性分析。
2.
At present, the slope stability analysis under action of reservoir water always begins with the determination of the location of phreatic surface.
目前,关于库水作用下的边坡稳定性分析,一般都是首先确定坡体内浸润面的位置,然后再进行稳定性分析,而工程中广泛采用通过经验概化的方法粗略地确定坡体内浸润面的位置。
3.
In the paper,some achievements of stability analysis by the authors are introduced,including the solution to phreatic surface during the change of water level,the application of strength reduction FEM in stability analysis and the application of embedded anti-slide piles in the controlling engineering.
其中,包括库水水位变化过程中浸润面位置的求解、有限元强度折减法在涉水岸坡稳定性分析及埋入式抗滑桩治理工程中的应用。
2) saturated surface
浸润面
1.
A few test results are of guiding significance to the understanding of actual distribution of saturated surface in heap and infiltrating course of leaching solution as well as to rational construction of heap and distribution of leaching solution for the improvement of recovery rate of valued constituent.
同时，经分析得出了一些有意义的试验结果，对于了解实际堆浸矿堆中浸润面的分布状况和溶浸液的渗透过程，合理地进行筑堆和布液以提高有用物质的回收效果具有一定的意义。
2.
Based on the review of researching on heap leaching at home and abroad, the saturated surface of heap leaching is researched deeply and thoroughly for the first time in nonlinear dynamics.
论文在综述国内外堆浸工艺研究成果的基础上,首次从非线性动力学角度,对堆浸浸润面进行了深入研究,目的在于揭示浸润面的演化机理,提出控制浸润面混沌的技术原型。
3) infiltrated surface
浸润面
1.
The seepage theory of slope heap leaching field was developed through analyzing the forming principal and significance of infiltrated surface.
通过分析堆浸工艺中浸润面的形成机理与研究意义,发展了倾斜堆浸场渗流理论,并建立了描述矿堆底板具有一定坡度时浸润面形态的模型方程。
4) seepage face
浸润面
1.
The dynamic flow condition of seepage face at the seaward boundary is investigated.
本文从经典的Boussinesq方程出发,在考虑浸润面影响的基础上,建立了基于有限差分法的滨海地区一维地下水运动数值模型。
2.
It is difficult to determine the seaward boundary condition due to the existence of seepage face;however,the effects of seepage face are always neglected in previous research,for instance,in the perturbation solutions of water table fluctuations due to spring-neap tides.
浸润面的存在给向海边界条件的确定带来一定的困难,而以往研究(例如大小潮水位波动的摄动解法)往往忽略浸润面的影响。
5) infiltrates surface
浸润面
1.
Single rank inverse broyden iterative method for a nonlinear problems and application to infiltrates surface of heap leaching process;
堆浸工艺中浸润面的非线性问题逆Broyden秩1迭代方法
2.
To study the mechanism of heap leaching process,Newton iterative method is applied to find the solution for nonlinear infiltrates surface equation.
为了研究堆浸工艺的机理,用牛顿迭代公式寻求浸润面的非线性方程的数值解,经过14次迭代的误差达到了,说明此算法收敛有效。
6) wet areas
浸润面积
1.
To estimate the geometric characteristics, especially wet areas and section areas, of three dimensional numerical conceptual aircraft models, a method based on surface elements is proposed.
为了获取三维数值化概念机模型的浸润面积和横截面积等几何特性 ,本文提出了一种基于离散化面元的估算方法。
补充资料：不看金面看佛面
1.同"不看僧面看佛面"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条