说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 优化试验
1)  optimization experiment
优化试验
1.
The optimization of concrete mix proportion is achieved through an optimization experiment on the raw materials of face-sheet concrete, variety-selection of applied dose, concrete mix proportion at Gaotang Reservoir.
通过对高塘水库面板混凝土原材料、外加剂品种的选取 ,进行混凝土配合比的优化试验研究 ,得出既满足施工要求 ,又满足设计强度、抗渗和耐久性要求的最优混凝土配合比。
2)  optimizing test
优化试验
1.
Therefore,the optimizing test on the sootblowing program is presented,which regroups the soot blowers,and based on the boiler parameter variations and the slagging,ashing degree,continually regulates sootblowing program to find the best for each boiler and to make selective sootblowing on boiler h.
长期以来,沙角C电厂锅炉吹灰器的投停都以固定不变的成组方式进行,吹灰模式存在很多问题,严重影响了机组的效率和安全运行,为此提出了吹灰程序的优化试验:对锅炉吹灰器重新分组,结合锅炉运行参数的变化,不断地调整吹灰模式,针对锅炉结焦积灰情况,制定出适应每台锅炉的针对性吹灰程序,选择性地对锅炉受热面进行吹灰,这样,一方面,继续有效地抑制锅炉结焦,另一方面大大提高了机组效率,保证了锅炉的安全经济运行。
2.
Random block method is adopted to further study on optimizing test of different RTB(red turpentine beetle) vegetalitas lure agent formula.
采用随机区组方法对红脂大小蠹不同配方的植物性诱芯野外进一步优化试验,研究结果表明:(S)-(+)-3-蒈烯的引诱效果最好;(R)-(+)-α-蒎烯完全没有引诱效果;少量添加柠檬烯、香叶烯、绿叶素,会减弱(S)-(+)-3-蒈烯的引诱效果。
3)  Optimizing experiment
优化试验
4)  optimization [英][,ɔptimai'zeiʃən]  [美][,ɑptɪmaɪ'zeʃən]
试验优化
1.
Analysis of Suspension Characteristic and Experimental Optimization Based on K&C Test;
基于K&C试验的悬架特性分析与试验优化
5)  sampling spot optimization
试验点优化
6)  orthogonal optimization test
正交优化试验
1.
The influence of technical parameters of temperature, pressure and time on vacuum diffusion welding of horizontally projected jet bits on the shear strength of the welding seam was studied by orthogonal optimization test.
利用正交优化试验方法研究了水平射流钻头真空扩散焊温度、压力和时间等工艺参数对焊缝抗剪强度的影响,并确立了相应的关系式,分析了温度、压力和时间等工艺参数对焊缝抗剪强度的独立影响和交互影响。
2.
The influences of the technological parameters of vacuum diffusion bonding of logging ceramic probe(Al2O3 ceramic to 45 steel) such as temperature,pressure and time on the shear strength of the bonging seam were studied by the orthogonal optimization test.
利用正交优化试验方法,研究了测井探头Al2O3陶瓷电极座与45钢基体真空扩散焊温度、压力和时间等工艺参数对焊缝抗剪强度的影响,并总结出相应的关系式,然后分析了温度、压力和时间等工艺参数对焊缝抗剪强度的独立影响和交互影响。
补充资料:大气暴晒试验、自然老化试验
分子式:
CAS号:

性质:又称大气暴晒试验、自然老化试验。将胶黏剂胶接的试样置于户外,选择气候有代表性的地点,在自然条件下,经过不同的暴晒时间后测定其性能变化。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条