1) plastic wye
塑料三通
1.
The design process of plastic wye injection mould is stated in detail from the analysis of plastic part ,the analysis of the process and the design of the struction.
从塑件分析、工艺分析、结构设计三方面详细阐述了常见塑料三通注射模的设计过程。
2) three-way plastic tube
塑料三通管
1.
The molding technology of three-way plastic tube with flexural core is analyzed and the molding faults in plastic injecting process are forecasted.
分析了带弯芯塑料三通管的注射成型工艺,并对成型过程出现的缺陷进行预测。
3) general-purpose plastics
通用塑料
1.
The progress in the modification of enhancing toughness and the anti-low temperature capability of general-purpose plastics and engineering plastics with POE is reviewed.
聚烯烃弹性体(POE)综合性能优异,广泛应用于通用塑料和工程塑料的增韧和抗低温改性中。
2.
The progress in the modification of general-purpose plastics and engineering plastics, with POE as modifier, is reviewed.
综述近几年聚烯烃弹性体(POE)与通用塑料、工程塑料共混改性的进展。
4) general plastics
通用塑料
1.
This paper briefly introduces the developments of new products and the current state at home and abroad of the anstatic agents(including nonionic,cationic,anionic and composite) for general plastics such as polypropylene,polyethylene,polystyrene and linear polyethylene.
简要介绍了通用塑料聚丙烯、聚乙烯、聚苯乙烯和线性聚乙烯等抗静电剂（非离子型、阳离子型、阴离子型、两性型和复合型）的国内外现状与新品种的开发。
5) San Tai Plastic
三泰塑料
1.
The present study took San Tai Plastic Company as an example,.
本文以三泰塑料公司为研究对象,分析企业在发展过程中存在的问题与失误,同时针对现状,提出战略与管理对策,以期使企业摆脱困境,得到持续发展。
6) three-core plastic wire
三芯塑料线
补充资料：各种增强改性塑料、塑料合金及制品
各种增强改性塑料、塑料合金及制品
督 一年种咐恤改日别州、喇料台金咬制品确厅脚爵‘卜厂曰佑
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条