1) air injection system
注气系统
1.
In order to promote domestic injection molding equipment with air assistant, introduced theconstructed the key technique of the equipment based on the traditional injection molding equipment,pointed out the construction of air injection system and the requirements for injection machine and injec-tion mold.
为促进气体辅助注射成型设备的国产化,介绍了在传统注射成型设备基础上构建该设备的关键技术,提出了气体辅助注射成型设备注气系统的组建及对注射机和注射模的要求,突破了传统注射成型的技术限制,可节约大量因引进进口设备所花费的资金。
2) gas injection control system
注气控制系统
3) super-charge petroleum system
超强充注油气系统
4) pouring system
浇注系统
1.
Study of the calculating formulas in the minimum section of the gray casting iron pouring system
灰铸铁件浇注系统最小截面积计算公式研究
2.
The injection molding flow of six different pouring system for air-condition panel was analyzed respectively by using Molding Plastics Advisers (MPA)software.
利用模流分析软件Moldflow Plastics Advisers(MPA)对空调机面板注塑模6种构型不同的浇注系统分别进行注射成型流动分析。
3.
The structural characteristics of the aluminum alloy tap part were analyzed, and the design of pouring system and die-casting die structure were introduced.
分析了铝合金水龙头零件的结构工艺性特点,介绍了压铸模的浇注系统及模具结构设计。
5) gating system
浇注系统
1.
Simulation and optimization of gating system of die-casting die for magnesium alloy AM60B part;
AM60B镁合金压铸模浇注系统的模拟与优化
2.
Principle of Designing Gating System for Die Cast Aluminum Alloy Mould;
设计铝合金压铸模具浇注系统类型的原则
3.
Optimization of Gating System for Gear Box of the Car Based on CAE System;
基于CAE分析的汽车齿轮室浇注系统的优化
6) water injection system
注水系统
1.
Study on anti-corrosion and anti-scaling technology of water injection system in Qianda oilfield;
前大油田注水系统防腐防垢技术的研究
2.
A hydroviscous speed-regulating clutch used in oilfield water injection system;
油田注水系统用液体粘性调速离合器
3.
Energy-saving technology by adjusting input voltage of electromotor in water injection system.;
注水系统电动机调端电压节能技术试验研究
补充资料：气注
气注 气注 九注之一。《诸病源候论·气注候》：“风邪搏于肺气所为也，肺主气，气通行表里，邪乘虚弱，故相搏之，随气游走冲击，痛无定处，故名为气注。”
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条