说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 中负荷处理系统
1)  Medium rate activatedsludge treatment system
中负荷处理系统
2)  medium-loaded system
中负荷系统
3)  Treatment Load
处理负荷
1.
Calculation of Treatment Load of Inclined Plate Settlers;
斜板沉降器处理负荷的计算
2.
The influences of the preheating temperature,mix pump speed and the structure parameters on the treatment load were studied through experiments.
基于油水的物化性质 ,对工业回收甲苯—水分散体系采用预热后再经斜板沉降器分离的工艺 ,研究了预热温度、混合程度及斜板结构参数对处理负荷的影响 。
4)  load management system
负荷管理系统
1.
Application of load management system to decreasing loss in technology;
负荷管理系统在技术降损中的应用
2.
The operation optimization of electric load management system;
电力负荷管理系统的运行优化
3.
Function development analysis of load management system;
负荷管理系统功能拓展经验浅谈
5)  power load management system
负荷管理系统
1.
Analysis of the new function of power load management system;
浅析电力负荷管理系统的新功能
2.
Design and realization of the concurrentcommunication in the power load management system;
负荷管理系统中的并发通信设计与实现
3.
This paper introduces the composition modes of the current power load management system,which mainly include the composition mode of the 230M special network,the GPRS composition mode,the telephone terminal composition mode,wire wideband system and fiber Ethernet,and analyses the merits and drawbacks of different compositions modes.
介绍了目前电力负荷管理系统的组成方式,主要有230M专网的组成方式、GPRS组网方式、电话终端组网方式、有线宽带以及光纤以太网等,分析了系统采用各组网方式的优缺点。
6)  load system
负荷系统
补充资料:AB变频器在中嘉污水处理厂自动控制系统工程的应用
中嘉无污水处理厂的总处理量是30万吨/天,共分三期兴建,第一期工程处理量为10万吨/天。根据中山市环保局的进水及出水水质要求,该厂采用了先进的氧化沟工艺来达到去除有机物及脱磷脱氧的要求。系统的主要处理工艺流程分为预处理、氧化沟、终沉池和污泥脱水四个部分。采用基于PLC 5 控制器成本低廉的远程通信和控制系统;保证污水处理过程的质量,使得出水水质符合规定的标准;应用先进的PID算法和闭环控制策略以维持化学药品的最佳平衡和最大限度地降低成本高昂的中和药品用量;变频器和智能马达控制器不仅避免电机启动时对电网的冲击,而且起到均衡节能、起停控制和速度调节的作用;友好的用户界面(MMI)和完善的报表输出系统使得管理人员可以很方便地控制、监测系统和排除系统故障,并能及时地得到系统处理过程中的数据,掌握系统的运行趋势。
控制系统所使用的主要软件、硬件设备如下:
PLC A-B PLC 5/30 
现场图形终端 A-B PanelView 1400E 
变频器 A-B 1336 PLUS 
马达软启动器 A-B SMC PLUS 
上位计算机 DELL PII350 
界面平台软件 RSView32 
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条