1) cold heading hexagon drife
镦六角冲头
2) upsetting hexagon die
镦六角模
3) inter-hexagon punch
内六角冲头
1.
On the basis of service conditions and failure forms of the inter-hexagon punches,some technology measures such as die materials optimization,strengthening and toughening treatment as well as surface treatment of QPQ were provided,and a type of high performance inter-hexagon punch was also developed.
在内六角冲头服役条件及失效形式分析的基础上,提出了模具材料优化、强韧化处理及QPQ表面处理等技术措施,研制出了一种高性能的内六角冲头。
4) cold forge dies
冷镦冲头
1.
The automobile differential shell bolt cold forge dies,which can only produce2,000bolts at their maximum,have a short and unstable life.
汽车差速器壳螺栓冷镦冲头使用寿命低 (仅生产 10 0 0~ 2 0 0 0只产品 ) ,且寿命长短不一 。
5) head punch
顶镦冲头
6) preform heading punch
初镦冲头
补充资料:自动冷镦机、多工位螺栓自动冷镦机
| |||||||
主要参数内容 | 国际先进 | 国内先进 | 国内一般 | 国内落后 | 评定方法及说明 | ||
(一)加工精度 | 参照GB9166-88、JB/T3053-91 | ||||||
1、冲头夹持器模孔中心线对夹持器后支承面的垂直度(mm) 在100长度上 | 0.008 | 0.01 | 0.015 | >0.015 | |||
2、凹模座模孔中心线对凹模后座支承面的垂直度(mm) 在100长度上 | 0.008 | 0.01 | 0.015 | >0.015 | |||
3、冲头夹持器模孔中心线对滑块行程的平行度(mm) 在100行程上 | 0.016 | 0.02 | 0.02 | >0.02 | |||
4、滑块行程对机身上与凹模座贴合的垂直面的垂直度(mm) 在100行程上 | 0.016 | 0.02 | 0.02 | >0.02 | |||
5、工件头部对工件杆部中心线的偏移量(mm) | <0.20 | 0.20~0.25 | 0.25~0.30 | >0.30 | |||
(二)生产率(件/分) | |||||||
20mm | >80 | 70 | 65 | <65 | |||
30mm | >60 | 50 | 45 | <45 |
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条