1) Hole-slot flat rupture discs
孔槽型平膜片
2) flat sheeet microporous membrane
平片式微孔膜
3) slotted templates
槽孔模片
4) flat tablets
平膜膜片
1.
Finite element method was applied to analysis the expansion and the last corresponding degrees of thermal expansion of silicone oil was achieved under two different shapes of tablets,which were flat tablets and wavy tablets.
文中主要就硅油、壳体基座及波纹片在250℃工作时由于不同的热膨胀系数而导致的膨胀不一致情况进行ANSYS仿真分析,研究了平膜膜片及波纹状膜片情况下的硅油热膨胀问题,最后相应地得到了硅油相对于壳体和波纹片的热膨胀率,同时分析得出了合理设计波纹片结构可以有效减小硅油热膨胀时所产生的附加压力,提高传感器的工作灵敏度与稳定性。
5) channel pass
槽式孔型
1.
An analysis is made of the Performance of the channel pass system while used in ■ 650 rolling mills for the trial production of flat - bulb steel for ship use, with the conclusion that this system can bring about a steady rolling down and top - quality rolled pieces.
分析在■６５０轧机上试制球扁钢时，采用槽式孔型系统的情况。
6) orifice relief
口型槽孔
补充资料：第二孔(继发孔)型缺损
第二孔(继发孔)型缺损
ostium secondary defect
是心房间隔在形成上发生障碍，一般缺损较大，多在卵圆孔附近称第二孔(继发孔)型缺损。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条