1)  rotating disc electrode
旋转园盘电极法
2)  rotation
旋转
1.
A Possible Mechanism of α Subunit 'Push' γ-Subunit Rotation in ATPase;
ATP合酶中α亚基推动γ亚基旋转的可能机制
2.
Successful experiences of rotation mining method at combined mining face;
综采工作面旋转采煤法成功经验
3.
Measurement of the rotational alignment of the distal femur with 3-dimensional CT;
三维螺旋CT重建股骨远端旋转力线的测量
3)  rotate
旋转
1.
The experimental results show that it can eliminate the phenomena of zigzag caused in image rotation and reduce the image distortion after image rotates many times.
图象旋转是图象处理中的一个基本操作,根据图象在邻近区域内连续的特点,该文提出一种基于高斯模板的图象旋转算法。
2.
Let P and Q be two nonintersecting simple polygons in the plane, this paper discusses the rotational movability of them if P rotates around a point and collides with Q .
设 P和 Q为平面内两个互不相交的简单多边形 ,若 P在平面内绕某点旋转 ,文中讨论了其旋转可移动性问题 。
4)  rotating
旋转
1.
Heat transfer performance of!heat pipe rotating about parallel axes;
平行轴旋转热管传热性能的实验
2.
Experimental investigations on the local heat transfer coefficient of rotating single circular impingement in a half-limited space;
旋转半受限单孔冲击局部换热特性实验
3.
Local heat transfer in a rotating U-shaped square channel with three channel orientations;
3种转角下旋转U形方通道的局部换热
5)  rotary
旋转
1.
Introduction of static bias push-the-bit rotary naviyational system;
静态偏置推靠钻头式旋转导向钻井系统介绍
2.
Improvement & application of rotary self-seal assembly in workover job;
旋转自封封井器在大修作业中的技术改进及应用
3.
Brief discussion on fully mechanized rotary mining method with hydraulic powered support;
综采支架旋转采煤法初探
6)  spinning
旋转
1.
Numerical simulation on complex flow field in air inlet of high-speed spinning ramjet extended range projectile;
高速旋转冲压增程弹用进气道复杂流场数值模拟
2.
The Three-Dimensional Kinematic Analysis on Spinning and Delivery Technique of Some Domestic Female Elite Hammer Thrower;
我国部分优秀女子链球运动员旋转及最后用力技术的三维运动学分析
3.
In this paper,a GPS receiver based on DRFM is proposed to enhance receiving ability in the spinning environment.
主要研究基于数字射频存储器(DRFM)解决旋转状态下GPS信号的跟踪和定位问题,并利用Zarlink产品设计芯片级GPS接收机。
参考词条
补充资料:旋转电极制粉法


旋转电极制粉法
rotating electrode comminuting process

xuanZhuand旧nji zhifenf。 旋转电极制粉法(护tating electrodeco, minutingProc郎的以金属或合金制成自耗电 极,其端面受电弧加热而熔融为液体,通过电极高速旋 转的离心力将液体抛出并粉碎为细小液滴,继之冷凝 为粉末的制粉方法。这种制粉方法子1974年首先由 美国核金属公司开发成功,其工作原理示于图。它在熔 融和雾化金属过程中完全避免了造渣和与耐火材料接 慈消除了非金属夹杂物污染源,可生产高洁净度的粉 末·_- -一_瞬_ 1一电弧;2一粉末:3一旋转自能金属或合金电极。4一固定钨电极 典型的旋转电极制粉设备是由一个直径达Zm多 的箱体组成,旋转自耗电极通过动密封轴承装入其中, 电极长轴水平地处于箱体中心线位置,电极旋转速度 高达1 5000~25。。0r/mino一为了避免钨污染,可在钨电 极处改用等离子炬,称为等离子旋转电极雾化制粉法 (P REP)放用电子束熔融自耗电极,称为电子束旋转 盘雾化制粉法(E BRD)。箱体内的保护气氛可选用惰 性气体,最好是氢气。因为它的热导率最高,几乎是氢 气咖磅沱既能提高冷却速瓦又可改善瓤眺。 旋转电极法制取的粉末,其粒度分布范围比较窄 (50一50如m),平均粒度可近似地认为与自耗电极旋〕疑潺{翼l辨瀚 流 理 夕右 钦 合金(Ti‘。Ai一4v)和镍基高温合金(例如美国牌号 IN10。和Rene,5)已成功地用于制造航空燃气涡轮发 动机压气机转子和涡轮盘等零部件。 ‘(再洪海)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。