1) horizontal curve radius
弯道平曲半径
2) bend
弯道
1.
The Experiment Research of Spur-dikes Influence on Flow Pattern in Bend;
丁坝对弯道水流流态影响的试验研究
2.
Aimed at the complex flow regime of the oxidation ditch bend,the effect of transverse circulatory flow and redistribution of velocity at the bend on sludge deposition was analyzed.
针对氧化沟弯道水流流态复杂的特点,分析了弯道横向环流和水流流速在弯道的重新分布对污泥沉积的影响,借助ANSYS FLOTRAN模块对设置偏置导流墙前、后的水流流速分布情况进行了模拟比较,探讨了偏置导流墙减少污泥沉积的机理,并研究了氧化沟弯道局部阻力和边墙超高的计算方法,从而为导流墙的设计提供参考。
3.
There are two bends designed with small curvature and large grade in the Xiaonanhai Reservoir Spillway due to the limitation of geology and landform.
重庆市小南海水库溢洪道由于地形地质条件的限制,设计成两个弯道且弯道的曲率小,坡降大。
3) river bend
弯道
1.
Modern 3D moving interface tracing technology-VOF(volume of fluid) method and standard k-ε model which are integrated in Fluent,are jointly used in the present study to numerically simulate the flow field of river bend.
应用大型流场分析软件Fluent,采用现代三维运动界面追踪技术VOF(流体体积)方法和标准k-ε模型耦合求解对圆心角为90°弯道的弯道水流三维流场进行了合理模拟,得出了河床剪应力的分布特征,为路基冲刷分析和合理防护措施的制定提供了理论分析的基础。
2.
A new measurement of line arrangement for river bend——deflection-tangent is presented,and its theoretical correctness is proved.
介绍了一种新的弯道放线测量方式“偏角一新切线法”,并论证了其理论上的正确性。
3.
Study on the three-dimensional flow field in the vicinity of river bend is helpful to understand the mechanism of subgrade scour along the bend,thus lay out reasonably precautionary measures and enhance the ability of prevention of scour of subgrade.
研究弯道水流的三维流场有助于认识沿河公路路基的冲刷机理并制定相应的防护措施,从而提高路基抗水毁的能力。
4) curved channel
弯道
1.
Research on sills for preventing freeboard in rapid flow curved channel;
斜槛在急流弯道控制超高的设计研究
2.
Experimental study on hydraulic behavior of supercritical flow in curved channel;
急流弯道的水力特性试验研究
3.
In order to investigate the shock wave propogation through curved channel, the experiment set of shock motion through curved channels has been designed at Facility Design & Instrumentation Institute of CARDC.
为了研究微波过弯道的传播，气动中心设计了微波过弯道的实验装置，它很容易拆卸并组成带10°发散的弯道、短形弯道和带各种角度的二元喷嘴。
5) curve
弯道
1.
Analysis of abutment sidewall failure mechanism for solid arch bridge on curve;
弯道上的桥台侧墙开裂原因分析
2.
Contrast analysis of calculating formula adaptive range in the position of curve water fetching hole;
弯道取水口位置计算公式适用范围的对比分析
3.
Discusses the Youth Road Bicycle Athlete Curve Technology the Fundamental Training;
谈青少年公路自行车运动员弯道技术的基础训练
6) crossover
弯道
1.
The effects on the aerodynamic performance inside the standstill parts as crossover bend and de-swirl cascade of the multistage centrifugal compressor caused by the circumferentially pre-swirling coming flow have been specially studied by using of CFD.
利用CFD技术,重点研究了来流周向预旋对多级离心压缩机级间弯道与回流叶栅等静止部件内气动性能的影响。
2.
More importance is attached to the aerodynamic performance of the stationary components inside the compressor,such as deswirl cascade and two types of crossovers.
通过CFD技术对某型多级离心压缩机内的流动进行了数值模拟,重点研究了多级离心压缩机级间装置如回流器、两类弯道内气动特点及其旋涡结构的特征,旨在揭示气流经弯道与回流器后气动参数的变化规律。
3.
Importance is attached on the aerodynamic performance for the crossover and deswirl cascade of the compressor,aiming to disclose the flow distortion induced by those stationary components of the compressor.
对弯道与回流器等多级压缩机级间的静止部件内的气动特点进行研究,旨在揭示气流经弯道与回流器后气动参数的变化特征。
参考词条
补充资料：曲平
1.曲法申恩，平处其罪。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。