|
|
1) scheme arrangement
方案布置
1.
This paper describes the scheme arrangement of construction settlement observation of Tan Shao Expressway, and put forwards the methods of preliminary analysis of foundation settlement data for dynamic control of embankment construction of the expressway based on the analysis of foundation settlement characteristics during construction.
介绍了潭邵高速公路施工沉降观测的方案布置情况 ,并在对施工中地基沉降特性分析的基础上 ,提出进行地基沉降数据初步分析的方法 ,用于潭邵高速公路路堤施工的动态控制。
2) layout plan
布置方案
1.
This paper introduces the main payout principles for the main workshop of 135 MW machine set,and draws the reasonable layout plan through comparing and optimizing the two layout plans.
介绍了电厂135MW机组主厂房的主要布置原则,并通过两个布置方案的比较优化后,得出合理的布置方案。
2.
Analyzing the relevant factors of logistics facility layout and based on Systematic Layout Planning method(SLP),the paper proposes a logistics facility layout procedure mode,analyzes and discusses the facility layout plan and evaluation in the procedure mode.
从物流设施布置相关因素分析入手,在SLP系统布置方法的基础上,提出了物流设施布置的程序模式,并对程序模式中的设施布置方案及评价进行了重点分析和探讨。
3) layout scheme
布置方案
1.
Research on layout scheme of gas turbine combined cycle units
燃气-蒸汽联合循环机组布置方案研究
2.
An experimental study was performed on the layout scheme of a pumping station to be built on the bank of a broad and shallow sediment-laden reach of the mainstream of the Yellow River,including the site selection,layout of water intake,simulation of floating ice flowing into the gate.
对黄河干流某宽浅多沙河段拟建泵站规划布置方案进行了泵站选址、取水头部布置、浮冰进闸模拟等的试验研究,试验结果表明:宽浅多沙河流岸边式取水泵站站址宜选在弯道顶冲点下游的送溜段;取水头部按迎水面与主流线平行的形式布置流态较为理想,采用叠梁闸形式可使洪枯水季节的取水安全及取水防沙得到最大限度的保证;岸边式取水泵站的进水流道会有浮冰进入,但数量远小于河道内的浮冰疏密度;站址区的岸坡防护与加固,应以不影响取水头部最佳水流条件为前提。
3.
This paper analyzes and approaches the layout from the angles of boiler thermal load,distribution of pulverized coal and investment ,qualitatively puts forward the following optimum layout schemes:(1)tube mills are transversely arranged in front of boiler and crossly connected with the corresponding burners(front-lef and rear-right ,or front-right and rear-left);(2)tub.
从锅炉热负荷、煤粉分配和投资角度对其进行分析探讨,定性提出球磨机炉前横向布置和同磨对应燃烧器全置炉后或全置炉前的优选布置方案,对同类型锅炉制粉系统的布置方案选择有一定的指导意义。
4) arrangement
[英][ə'reɪndʒmənt] [美][ə'rendʒmənt]
布置方案
1.
Some different arrangements of the ice storage system have been listed.
围绕这一主题 ,着重介绍了冰蓄冷空调系统几种常用的布置方案 ,从可行性和经济性等多方面加以分析区
2.
The characteristic of it and the strength, arrangement of its shear connectors are studied.
本文研究了桁梁结合梁的受力特征，针对Ｗ桥的具体情况试验研究了栓钉的承载力和布置方案，该成果已用于Ｗ桥的设计。
5) arrangement scheme of substatbn
变电站布置方案
6) multies shaft arrangement
多轴布置方案
补充资料：ANSYS SOLID65环向布置钢筋的例子
ANSYS SOLID65环向布置钢筋的例子
! 一个管道，环向配筋率为1%，纵向配筋率为0.5%，径向配筋率为0.1%
! 作者: 陆新征 清华大学土木系
!
FINISH
/CLEAR /PREP7
!*
! 单元属性
ET,1,SOLID65
!*
KEYOPT,1,1,0
KEYOPT,1,5,0
KEYOPT,1,6,0
KEYOPT,1,7,1
!*
!实参数1：不同方向配筋
R,1,2,.001, , ,2, .01,
RMORE, 90, ,2,.005 ,90 ,90 , !材料属性
!混凝土基本材料属性
MPTEMP,,,,,,,,
MPTEMP,1,0
MPDATA,EX,1,,30E2
MPDATA,PRXY,1,,.2
!屈服准则
TB,MISO,1,1,5,
TBTEMP,0
TBPT,,0.0005,15
TBPT,,0.001,21
TBPT,,0.0015,24
TBPT,,0.002,27
TBPT,,0.003,24
!破坏准则
TB,CONC,1,1,9,
TBTEMP,0
TBDATA,,.5,.9,3,30,,
TBDATA,,,,1,,,
MPTEMP,,,,,,,,
MPTEMP,1,0
!钢材基本属性
MPDATA,EX,2,,200E3
MPDATA,PRXY,2,,.27
!屈服准则
TB,BISO,2,1,2,
TBTEMP,0
TBDATA,,310,2E3,,,, ! 管道内径和外径
CYL4,0,0,3000, , , ,10000
CYL4,0,0,2000, , , ,10000
VSBV, 1, 2 ! 定义局部柱坐标
CSWPLA,11,1,1,1,
KWPAVE, 11
WPRO,,-90.000000,
VSBW, 3
WPCSYS,-1,0
KWPAVE, 1
WPRO,,,-90.000000
VSBW,ALL ESIZE,500,0,
! 注意：设定单元局部坐标
VATT, 1, 1, 1, 11
!*
VSWEEP,ALL
/DEVICE,VECTOR,1
/ESHAPE,1.0
/REPLO
! 注意：红色代表最大配筋方向，绿色代表其次，蓝色表示最小配筋方向
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条
|