1) differential current resistance component
电阻性差流
2) resistive current
阻性电流
1.
Research on measurement of resistive current in XLPE cable using capacitive current compensation method;
用容性电流补偿法检测XLPE电缆中阻性电流的研究
2.
Analysis on Measuring Error of Resistive Current in Metal Oxide Arrester
氧化锌避雷器阻性电流误差分析
3.
Dielectric properties and resistive currents of ZnO nonohmic materials prepared with different technical procedures were investigated.
实验发现并理论推导了ＺｎＯ非欧姆陶瓷元件的阻性电流正比于其电容和压敏电压的乘积，这一关系可作为ＺｎＯ元件的质量控制手段。
3) Resistance Current
阻性电流
1.
Analysis and Discussion for Zinc-Oxide Arrester s Defects and its Resistance Current;
氧化锌避雷器缺陷与阻性电流的分析探讨
2.
The operation condition of metal oxide surge arrester (MOA) in system can be judged by using the hotline detection method, which collects the voltage and leak current signal of MOA on the spot, then calculates the resistance current of MOA by extraction algorithm software of resistance current.
采用带电检测氧化锌避雷器(MOA)的方法,现场采集MOA的电压和总泄漏电流信号,然后由阻性电流提取算法软件计算得到MOA的阻性电流,以此可判断MOA在系统中的运行状况。
3.
Through analysis to internal moisture in MOA,full currernt and resistance current increase under operation voltage,especially to the feature of larger resistance current component,abnormal data in phase C are found in live testing shortly after the group of MOA are put into operation.
针对MOA内部受潮劣化后,其运行电压下全电流及阻性电流均增大,尤其是阻性电流分量增大幅度更大的特点,在对一组投运不久的MOA进行带电测试,发现C相数据异常,随后对同期产品逐一进行了带电测试,对数据异常者进行了综合分析判断,确认了MOA的缺陷是制造时由于内部受潮或密封不良造成。
4) resistive leakage current
阻性电流
1.
Monitoring the basic component ir and the third component i3r of the resistive leakage current can reflect the MOA s operation state.
阻性电流中的基波分量ir和三次分量i3r可以反映金属氧化物避雷器(MOA)的运行状况。
2.
In this paper, research status of MOA resistive leakage current on-line monitoring is introduced, different monitoring methods are analyzed and influencing factors of monitoring are presented, such as influence of power system s harmonic voltages, inter-phase interference, samp.
本文介绍了目前MOA阻性电流在线监测的研究现状；详细分析了各种阻性电流在线监测方法的优缺点；提出影响MOA阻性电流监测的因素和问题，如谐波电压对阻性电流监测的影响，相间干扰对阻性电流监测的影响，全电流的取样方法对阻性监测的影响，并且针对其中的一些问题作了详细的研究。
3.
Fault and aging of MOA can be found timely through on-line resistive leakage current monitoring system.
监测流过MOA的阻性电流可以及时的发现其老化或劣化现象。
5) differential anode resistance
差分阳极电阻，交流电阻
6) MOA resistive current
MOA阻性电流
1.
The key to the detection of MOA resistive current is the detection of the phase difference between fundamental component of voltage and fundamental component of leakage current.
MOA阻性电流检测的关键在于电压基波分量与泄漏电流基波分量相位差的检测。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条