说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 拟力
1)  pseudo-force
拟力
2)  Pseudo-static method
拟静力法
1.
Improvement of pseudo-static method for slope stability analysis;
拟静力法边坡稳定分析的改进
2.
Comparison of the actual behavior resulting from the testes and those from the pseudo-static method and rigidity-reduction method indicates that the dynamic p-y curves from the tests and f.
将试验得到的实际p-y曲线与采用拟静力法和以API规范为基础的折减系数法计算出的p-y曲线进行对比,结果表明:(1)液化土层中试验得到的桩真实p-y响应及由拟静力法和折减系数法得到的结果都呈非线性变化,三者极限状态有接近一致的趋势,但变化过程差异明显;(2)采用拟静力法和折减系数法都会使液化土层桩基础侧向反力迅速增长,很快达到屈服极限,远远超过实际情况,会导致相当保守的结果;(3)液化进程中控制桩p-y响应的是土体位移而非惯性力,因而拟静力法和折减系数法的原理不适合桩-液化土体动力相互作用分析,不能用于液化土层中桩基础地震响应的计算。
3.
Based on the pseudo-static method,the reinforcement measures of anti-slide piles and their combination with anchor bolt frames were investigated with centrifuge model tests and numerical simulation in order to probe into the failure mechanism of deposit-on-slope reinforcement under an earthquake.
为探讨地震作用下斜坡堆积体的加固破坏机理,基于拟静力法理论,采用土工离心模型试验技术和数值模拟方法,对采用抗滑桩、抗滑桩联合锚杆框架2种加固措施进行了对比分析。
3)  Hydrodynamic simulation
水力模拟
1.
With the hydrodynamic simulation experimental method,the foundry process for the heavy size aluminum casting has been simulated and analyzed.
采用水力模拟试验方法,对某特大型铝合金铸件的铸造工艺进行模拟研究和分析,针对原工艺中的浇注系统设计不合理、系统的开放比过大以及系统的集渣消能段的连接段的设计缺陷等存在的问题,采取了改变原浇注系统开放比和采用响尾蛇集渣消能系统等改进措施,使改进后的浇注系统充型平稳顺利,流量均匀,确保了铸件一次浇注成功。
4)  pseudopressure
拟压力
1.
The pseudopressure product in the equation of two phase fluid index of the oil and gas condensate was divided into the product of the two integral functions, one product function related to the physics properties of the high pressur.
提出将凝析油气两相指数式方程中的拟压力积分分解为两个积分函数之积,一个积分函数与流体高压物性有关,另一个积分函数与流体的有效渗透率有关。
2.
The model is solved by using pseudopressure.
利用拟压力采用非稳态方法求解气藏水平井的产能模型,预测了裸眼完井、射孔完井和压裂完井的水平井气井产能,分析了影响产能的因素,并将其与直井压裂的产能进行了对比。
3.
According to the superposition principle, the formula of dimensionless pseudopressure is derived,the new comprehensive interpreting typical curve is developed, and its character is discussed.
根据叠加原理,得到了测压周期的无量纲拟压力表达式,研制了新型综合解释典型曲线,讨论了典型曲线特征。
5)  pseudo-pressure
拟压力
1.
The application of the pseudo-pressure was quoted in the deformed media reservoir; furthermore, the permeability modulus definition was used.
将拟压力应用到变形介质中,引入渗透率变异系数,推导了考虑渗透率影响的产量公式。
2.
The pseudo-pressure productivity equation can be used to reliably predict the individual well productivity and producing pressure drop, and the average.
以克拉 2气田现有产能测试资料为基础 ,分别确定了各次测试的拟压力和压力平方法无阻流量 ,根据无阻流量与地层系数的关系 ,建立了普遍适用于该气田主力产气层的典型二项式产能方程。
3.
Based on the material balance equation of the constant-volume gas reservoirs,the relationship between the formation pressure and deviation factor and the relation curve between the formation pressure and pseudo-pressure under the condition of constant formation temperature are obtained by Z-factor calculation s.
依据定容性封闭气藏物质平衡方程,在已知天然气密度、原始地层压力和地层温度等条件下,通过偏差因子软件计算得到地层温度恒定条件下地层压力与偏差因子的关系以及地层压力与气藏的拟压力之间的关系曲线,利用累积产量数据得到计算任意时刻气藏地层压力的新方法。
6)  Hydraulic simulation
水力模拟
1.
Study on Hydraulic Simulation and Numerical Simulation of Large Aluminum Alloy Casting;
大型铝合金铸件水力模拟与数值模拟的研究
2.
This paper described the mixed state of transitional zone of dippe r teeth for bimetal composite cast by mean of hydraulic simulation with fluids o f different viscosity.
用不同粘度的流体通过水力模拟的方法近似地描述了双金属斗齿过渡区的混 合状态 。
3.
Based on the similarity principle,the casting process of piston rings has been investigated by hydraulic simulation in the paper,and the method of reducing rejected products has been searched.
本文根据相似原理 ,介绍了利用水力模拟的方法 ,研究活塞环的浇注过程 ,寻找降低废品的途径。
补充资料:赤力力
1.亦作"赤历历"。 2.象声词。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条