说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 矿浆碱度
1)  pulp alkalinity
矿浆碱度
2)  pulp consistency
矿浆浓度
1.
It's not satisfied with the convertional PID control because of the frequent fluctuation of the pulp consistency resulting from the high nonlinearity of the mineral grinding process and the random disturbances,hence, a neural network PID controllor is designed to control the pulp consistency.
由于磨矿过程高度非线性和随机性扰动的影响 ,引起矿浆浓度频繁波动 ,采用常规的PID控制难以取得满意的效果 ,因此设计了一种基于神经网络的PID控制器控制矿浆浓度 。
2.
It s not satisfied with the convertional PID control because of the frequent fluctuation of the pulp consistency resulting from the high nonlinearity of the mineral grinding process and the random disturbances,hence, a neural network PID controllor is designed to control the pulp consistency.
由于磨矿过程高度非线性和随机性扰动的影响 ,引起矿浆浓度频繁波动 ,采用常规的PID控制难以取得满意的效果 ,因此设计了一种基于神经网络的PID控制器控制矿浆浓度。
3)  ore pulp density
矿浆密度
1.
There is statistical fluctuation of measurement value when the ore pulp density is measured on-line with radiation.
用γ射线在线检测矿浆密度测量值存在统计涨落。
4)  pulp density
矿浆浓度
1.
Experiment study taken for finding out basic method for reduction of ash content in flotation concentrate for some plant,which are: lowering down of pulp density,increasing contact time of collector and reagent addition by steps;realized thereof that,on ensuring relative high concentrate yield,its ash content reduced by three percent points.
试验研究了降低某矿煤泥灰分的基本方法,采取降低矿浆浓度、延长捕收剂接触时间及分次加药等措施,实现了在保证较高精煤产率的前提下,浮选精煤灰分降低约3百分点。
2.
When pulp density was 2%,the mixed culture showed good bioleaching efficiency at 45 and 50 ℃,the copper extraction efficiency was 75.
混合高温菌在45和50℃浸矿效果较好,在2%的矿浆浓度下,经过10天的浸出,浸出率分别达到75。
5)  alkali-activated slag cement mortars
碱矿渣水泥砂浆
1.
The carbonation depth of alkali-activated slag cement mortars decreases with content of alkali equivalent increasing in the range of 3% to 6%.
研究了碱当量(以氧化钠当量计)、水胶比和胶砂比对碱矿渣水泥砂浆抗碳化性能的影响,并与硅酸盐水泥砂浆进行了对比试验。
6)  sinter basicity
烧结矿碱度
补充资料:I型纸碱度硫铝酸盐水泥
分子式:
分子量:
CAS号:

性质:简称I型低碱度水泥。以无水硫铝酸钙为主要成分的硫铝酸盐水泥熟料,配以一定量的硬石膏磨细而成,具有碱度较低特性的水硬性胶凝材料。分为525、425和325三个标号。用作玻璃纤维增强水泥复合材料。525 I型主要适用于喷射工艺、425 I型主要适用于抄取工艺生产玻璃纤维增强水泥制品。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条