1) longitudinal and transverse bed deformation
河床纵向及横向变形
2) cross-sectional and longitudinal ground settlement
横向与纵向变形
3) longitudinal deformation
纵向变形
1.
Study on effect of construction loads on longitudinal deformation of adjacent metro tunnels;
地面新施工荷载对临近地铁隧道纵向变形的影响分析研究
2.
Through the mechanical analysis, the differential equation for the longitudinal deformation of cold forming steel is derived, and the formula for longitudinal rotation angle is obtained.
对冷弯型钢的纵向变形过程进行了力学分析，得到了变形微分方程，求得了转动角的理论公式，并对其变形形状进行了分析计
3.
The longitudinal deformation of metro station in soft clay is usually controlled by thickening the flank wall and floors and increasing the longitudinal stiffness of the station,which will sometimes result in the increase of thermal stress and dry shrinkage stress of concrete and thus cause crack and leakage in the structure.
对软土地区地铁车站纵向变形,通常采用加大车站侧墙和顶、楼板的厚度及提高车站的纵向刚度等方法进行控制,这往往会导致混凝土温度应力和干缩应力的增大,从而引起结构开裂渗水。
4) longitudinal deformation
纵向形变
5) transverse deformation
横向变形
1.
- e curve and less transverse deformation will be.
结果表明:混凝土强度越高,应力-应变关系线性段比例越高,横向变形越小,说明越接近均质材料。
2.
,transverse deformation and the ratio of compressive strength to flexural strength(σ_C/σ_F) in order to evaluate the effect of SAE latex on the toughness of cement mortar.
采用横向变形和压折比这2种方法表征了苯丙乳液水泥砂浆的韧性,研究了苯丙乳液对水泥砂浆韧性的影响,并着重探讨了这2种表征方法的关系。
3.
Based on the construction of the North Channel Bridge of Zhu-jiang Huangpu Bridge,the transverse deformation behavior of segments were investigated by mixed finite element model with consideration of the influenced factors such as non-uniform temperature,the location and stiffness of longitudinal truss-like spacer plate.
以黄埔大桥北汊桥独塔双索面扁平钢箱梁斜拉桥为工程背景,采用混合单元建立三维有限元模型,分析了梯度温度变化、桁架式纵隔板位置和刚度对悬拼施工中钢箱梁的横向变形问题的影响,并提出了一些相应的优化措施。
6) transverse deflection
横向变形
1.
Two laser displacement sensors were also used to detect transverse deflection of the saw blade and sawing profile on .
该文应用远红外温度传感器测试锯片沿半径方向的温度分布,两个激光位移传感器分别测量了锯片在外边缘模拟加热条件下锯片的横向变形和锯切工件上的锯痕高度,研究分析了不同温度分布、转速、进给速度、径向槽分布和适张状态下锯片横向变形与锯痕高度的关系。
2.
In this paper, the nonlinear transverse deflection or buckling is analyzed for unsymmetrical composite laminates under loads in plane by means of the generalized Fourier series method.
本文利用广义富里叶级数法对非对称复合材料层板在面内载荷作用下的非线性横向变形或屈曲问题进行了分析。
补充资料：本体纵向变形
分子式：
CAS号：
性质：物体只在一个方向上有尺寸变化，而在另两个互相垂直方向上无变化的变形方式。是使材料在单一方向受力，另外两个方向应力为零的形成的。合成纤维工业生产中广泛采用的牵伸工艺就是通过本体纵向变形来大幅度提高纤维强度的。
CAS号：
性质：物体只在一个方向上有尺寸变化，而在另两个互相垂直方向上无变化的变形方式。是使材料在单一方向受力，另外两个方向应力为零的形成的。合成纤维工业生产中广泛采用的牵伸工艺就是通过本体纵向变形来大幅度提高纤维强度的。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条