1) minimum reinforcements
最小配筋
1.
Analysis of shrinkage stress and recommendations on minimum reinforcements in fully restrained concrete slabs;
两端嵌固混凝土板的温度收缩分析及最小配筋
2) minimum reinforcement ratio
最小配筋率
1.
Simplied calculation to the minimum reinforcement ratio of flexural members to be content crack;
满足裂缝要求的受弯构件最小配筋率的简化计算
2.
Based the definition of the minimum reinforcement ratio of the reinforced concrete column,the minimum reinforcement ratio of the compressive and flexural concrete members reinforced with FRP tendons was introduced.
分析了FRP筋混凝土压弯构件发生受拉破坏时混凝土的等效应力图,依据钢筋混凝土结构最小配筋率的定义,给出了FRP筋混凝土压弯构件的最小配筋率。
3) minimum amount of reinforcing steel
最小配筋量
1.
Evaluation on minimum amount of reinforcing steel in bent component of reinforced concrete box girder;
钢筋混凝土箱形截面受弯构件最小配筋量的计算
4) minimum ratio of reinforcement
最小配筋率
1.
In accordance with The Code for Designing Concrete Structures and based on the formula for calculating maximum crack width, some formulas for computing minimum ratio of reinforcement to effective tensile region which satisfy the requirement of crack width are derived.
依据现行《混凝土结构设计规范》最大裂缝计算公式及其验算条件,推导出相关公式,编程计算出满足裂缝宽度要求的有效受拉区最小配筋率,并汇编成表格供直接计算满足裂缝宽度要求的配筋时查用。
5) minimum steel ratio
最小配筋率
1.
The minimum steel ratio in RC beams for circular cross section is studied,according to the principle of which the flexure strength of RC beams is not less than the cracking moment of plain concrete beam under the same conditions.
依据钢筋混凝土受弯构件的极限承载弯矩不小于相同条件下素混凝土受弯构件的开裂弯矩的原则 ,导出了钢筋混凝土圆形截面受弯构件的最小配筋率 ,结果表明圆形截面的最小配筋率比矩形截面大。
6) minimum shear reinforcement
最小抗剪配筋
1.
The influences of axial tensile force,minimum shear reinforcement,the ratio of reinforcement and the class of concrete were considered.
试验中主要考虑轴向拉力、最小抗剪配筋、配筋率、混凝土强度等级等因素对弯、剪、轴拉复合受力状态下钢筋混凝土梁的承载能力的影响。
补充资料：最小辐亮度与最小辐照度(见核爆炸火球)
最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance
zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条