说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 干信比
1)  JSR
干信比
1.
BER is a measure of judging the communication quality,JSR is a method of judging jamming effecetion,and the blocking rate of linke is a very important parameter of judging net sevice.
不同通信体制下对链路干扰的效果是不同的,误码率是衡量通信质量的重要参数,干信比是对干扰效能的衡量指标,而链路阻塞率则是对网络服务质量进行描述的具体参数,研究不同通信体制下3种变量之间的关系对地域通信网干扰研究具有十分重要的意义。
2)  jamming to signal ratio
干信比
1.
The jamming effect is represented by jamming to signal ratio,and the results show that the earth station can be jammed strongly based on the ar.
以无人机为例,利用STK和MATLAB软件仿真了干扰过程,并通过计算接收信号的干信比得到干扰效果,结果表明该方法计算的区域能够实现对地面站的高强度干扰。
3)  signal-to-jamming ratio
"信/干"比
4)  signal to interference ratio
信干比
1.
With the interference factor added into the power control equations, a calculation method has been derived, which demonstrates the relationship between the outage probability, the sensitivity of the base station receiver, the maximum transmission power of the mobile station, the expectation of signal to interference ratio(SIR), the coverage radius and the capacity of the cell.
在功率控制方程中加入干扰因子后 ,推导了中断概率、基站接收机灵敏度、移动台最大可允许的发射功率、信干比的期望值、路径损耗与小区覆盖半径、小区容量的关系式 ;在 2GHz频率 ,宽带、各种速率时 ,计算了基站接收信号的信干比、小区容量和小区的覆盖半
5)  SIR [英][sɜ:(r)]  [美][sɝ]
信干比
1.
A Novel SIR Estimation Technique in CDMA Systems;
一种新的CDMA系统信干比估计方法
2.
SIR Measurement Research & Implementation in Base Station of WCDMA Telecommunication System;
WCDMA系统基站信干比测量研究及实现
3.
An integrated power and rate control scheme was proposed, based on SIR(signal to interference ratio) balancing in this kind of CDMA systems.
为了使移动通讯系统获取最大容量,针对可变扩频因子码分多址接入(CDMA)系统,给出了一种基于信干比(SIR)平衡的功率速率联合控制方案。
6)  signal to interference and noise ratio
信干噪比
1.
In this paper, a general expression for the output signal to interference and noise ratio,SINR(W), is derived.
推导出窄带波束形成后干扰抵消器(简称PIC)的输出信干噪比(SINR(W)的一般表达式。
补充资料:视频信噪比
       “噪声”的简单定义就是:“在处理过程中设备自行产生的信号”,这些信号与输入信号无关。对于多媒体硬盘播放器来说,信噪比都是一个比较重要的参数,它指音源产生最大不失真声音信号强度与同时发出噪音强度之间的比率称为信号噪声比,简称信噪比(Signal/Noise),通常以S/N表示,单位为分贝(dB)。对于多媒体硬盘播放器来说,该值当然越大越好。

    目前多媒体硬盘播放器的信噪比有56dB、60dB、65dB、85dB、90dB、95dB等等,我们在选择多媒体硬盘播放器的时候,一般都选择60dB左右的,但即使这一参数达到了要求,也不一定表示机子好,毕竟它只是多媒体硬盘播放器性能参数中要考虑的参数之一。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条