1)  a prior estimate
插值不等式
1.
By using a prior estimate in the weighted space,the existence of the global solution for the damped generalized coupled nonlinear wave equations is obtaine
研究了一类非线性波动方程组解的渐进性质 ,利用Sobolev插值不等式 ,对时间t做了一系列先验估计 ,并得到了整体解的存在性 。
2)  Sobolev interpolation inequality
Sobolev插值不等式
1.
On the Sobolev interpolation inequality;
关于Sobolev插值不等式
3)  interpolation
插值
1.
Wavelet transform-interpolation-Elman neural network spectrophotometry for the simultaneous determination of copper,iron and nickel in aluminium alloy with 5-Br-PADAP;
小波变换-插值-Elman神经网络5-Br-PADAP分光光度法同时测定铝合金中铜铁镍
2.
An integrated genetic-neural-Kriging interpolation method for reservoir property and its application;
储层属性的遗传神经克里金插值方法及其应用
3.
Automatic method of first break picking based on edge detection and spline interpolation.;
基于单道边界检测和样条插值的初至波自动拾取
4)  interpolate
插值
1.
A technique of treatment for measured data in engineering based on the principle of interpolate;
基于插值原理的工程测试数据处理方法
2.
For ensuring quality of data reconstructing,it is important to select an appropriate interpolate methods.
在密集井群条件下,利用测井数据对地层曲面和三维储层属性进行插值重构是正确认识地质构造和油藏表征的重要手段,确定性插值是对油藏构造和属性建模的手段之一,选取合理的插值方法是保证重构质量的根本。
3.
The TOA array of intercepted radar signals is interpolated at first.
介绍了一种新的基于频谱分析的脉冲重复频率估计方法,该算法先对雷达侦察信号TOA序列插值,然后采样进行FFT计算得到频谱,最后对其频谱进行加权等处理得到PRF估计值。
5)  Interpolating
插值
1.
A new Interpolating algorithm for β-spline curve and Its application;
β样条曲线插值分析及其应用
2.
Shape adjust based on surface of interpolating of Doo-Sabin subdivision;
插值Doo-Sabin表面形状调节
3.
Based on the advantages of subdivision surface modeling and the importance of interpolating boundary curves in engineering surface, a new interpolating Catmull-clark subdivision by boundary sampling is proposed in this paper.
提出了基于边界采样的插值CatmullClark细分曲面造型方法。
6)  insert value
插值
参考词条
补充资料:Harnack不等式(对偶Harnack不等式)


Harnack不等式(对偶Harnack不等式)
quality (dual Hatnack inequality) Harnack in-

【补注】一直到G的边界的H助nack不等式,见【AZI.l翻..‘不等式(对停H山丸朗k不等不)[ Har.改沁-勺函勺(d切红Hat’I犯‘k如为uaJ卿);rap.姗二p魄HcT助(月加湘oe)] 给出正调和函数的两个值之比u(x)/“(y)的上界和下界估计的一个不等式,由A.Hai,剐火(汇IJ)得到.令u)0是n维E议当d空间的区域G中的一个调和函数;令E。(y)是中心在点y处半径为;的球{x:}x一y!<;}.若闭包万了刃.CG,则对于所有的、“凡(,),o0是常数,亡“(省:,…,氛)是任一。维实向量,叉‘G.不等式(2)中的常数M仅依赖于又,A,算子L的低阶项系数的某些范数以及G的边界与g的边界之间的距离. fy,1, …粤馨 对于形如u:+Lu“0的一致抛物型方程(算子L的系数可以依赖于t)的非负解:(x,t),类似于1压ar-恤比不等式的不等式也成立.在此情形下,对于顶点在点(y,动处开口向下的抛物面(图a) {(x,t川x一,I’<。,(T一t),:一v,簇t簇:}的内部的点(x,t),只能有单边的不等式(fs」): u(x,r)(M妇(y,T),这里,M依赖于y,T,又,A,料,,,算子L的低阶项系数的某些范数,以及抛物面的边界与在其中“(义,t))0的区域的边界之间的距离.例如,如果在柱形区域 Q二Gx(a,b],中“〕O,此外,歹CG,并且如果刁G与刁g之间的距离不小于d(>0),而d充分小,那么在gx(a一矛,bJ中不等式 。(、.t、___/,、一。1,.:一:.八 1。,二之二止,二止匕成几11止二一一丈‘.+一+11 u气y,T)\下一I“/成立(协J).特别地,如果在Q中u)0(图b),且如果对于位于Q中的紧集Q,和QZ有 占“们山n(t一:)>0, (义,t)‘Q- (y.下)〔QZ那么有 n知Lxu(x,t)簇M nunu(x,t), (x,‘)‘QZ(x,‘)‘Q-其中M“M(占,Q,QI,QZ,L).函数 ·、·,‘卜exn(‘睿,、‘一暮“:)—对于任意的k,,…,气,它是热方程u,一△拟“0的解—表明在抛物型情形下双边估计的不可能性,
说明:补充资料仅用于学习参考,请勿用于其它任何用途。