1) hydrate expand ratio
水化膨胀率
1.
The brick has nicer characters include low hydrate expand ratio, well anti-freese quality and well resist-alkali.
通过调整配料及其化学组成,在一定温度下,采用低温素烧高温釉烧,可烧制高性能面砖,特别对降低砖的水化膨胀率,改善抗冻性和耐碱性能收到明显的效果。
2) hydration swelling
水化膨胀
1.
Swelling characteristics and hydraulic properties of GCLs under vertical stress were studied through hydration swelling tests and permeation tests.
通过水化膨胀试验和渗透试验研究了GCL在竖向应力作用下的膨胀特性和渗透性能,并分析了正应力和加压水化顺序的影响。
3) volume expansibility
吸水膨胀率
1.
The results showed that the volume expansibility of water swollen rubber increased with the increasing amounts of water-Absorbing resin, but its physical properties decreased.
结果表明,吸水膨胀橡胶的吸水膨胀率随吸水树脂用量增加而增大,拉伸强度和拉断伸长率随吸水树脂用量增加而降低;随炭黑用量增加,物理机械性能提高,但体积膨胀率明显下降;建立的数学模型能较好地拟合炭黑和吸水树脂用量与胶料各项性能之间的关系。
2.
The results show that the volume expansibility of water swelling rubber increases with the increase of amounts of water-absorbing resin,but its physical properties decreases.
结果表明 :吸水膨胀橡胶的吸水膨胀率随吸水树脂用量增加而增大 ,拉伸强度和扯断伸长率随吸水树脂用量增加而降低 ;硫化剂用量越多橡胶吸水膨胀率越小 ;橡胶吸水膨胀率随白炭黑用量增加而略有上升。
4) Thickness swelling rate
吸水厚度膨胀率
1.
The radial and tangential thickness swelling rates of compressed Chinese fir wood were determined and analyzed in different water temperature and interval.
测定和分析了杉木压缩木在不同水温、不同时段的径向和弦向吸水厚度膨胀率 结果表明,不同条件下,径向和弦向吸水厚度膨胀率随时间变化的速度和幅度不同,达到径向和弦向最大吸水厚度膨胀率的时间也不同 该研究结果为杉木压缩木的生产和利用提供了科学的理论依
5) TS
吸水厚度膨胀率
1.
THE EFFECTS OF ALL MAIN MANUFACTURING FACTORS ON THE THICKNESS SWELLING IN PARTICLEBOARD;
制造工艺因素对刨花板吸水厚度膨胀率的影响
2.
By tracking test on the different density particleboard made of Populus ussuriensis and Larix gmelini ,and the different thickness wood of Populus ussuriensis and Larix gmelini , this paper showed the thickness swelling equation of particleboard and wood are quite the same and coincide rather well with the theoretical deduction, that is TS(t)=a-b e -t/τ .
对不同密度杨木刨花板、落叶松刨花板及不同厚度杨木、落叶松在不同方向的吸水厚度膨胀率进行追踪测试 ,然后进行回归拟合 ,结果表明 ,刨花板和木材的吸水厚度膨胀率方程与理论推导结果能很好的吻合 ,方程的数学形式都为 :TS(t) =a -be-t τ。
3.
We analyzed the effects of hot pressing time,resin content,board density,and ratio of wood shavings to tobacco stems on the particleboard properties including modulus of rupture(MOR),internal bonding strength(IB)and thickness swelling rate of water absorption(TS).
初步探讨了实验室条件下烟秆/木材刨花板的生产工艺,研究了热压时间、施胶量、密度、木刨花加入量等因素对板材的静曲强度、内结合强度、吸水厚度膨胀率的影响。
6) thickness swelling
吸水厚度膨胀率
1.
Influence of thickness swelling on the quality stability of laminate floor covering;
吸水厚度膨胀率对强化木地板质量稳定性的影响
2.
A test study was made on the influence of water temperature on the thickness swelling of medium density fireboard (MDF).
通过验证试验,探讨了水温变化对中密度纤维板吸水厚度膨胀率的影响程度,并对日常检测中如何保证水温符合检测要求提出了相应的建议。
3.
The study was conducted to make compressed bamboo by hot compressing microwave-softened bamboo of four different ages, during which the effect of compression rate, compress temperature and compress time on thickness swelling and recovery rate from compressive deformation was analyzed through orthogonal experiments.
运用正交分析法分析压缩率、热压温度、热压定型时间对密实化竹材的吸水厚度膨胀率和压缩变形恢复率的影响。
补充资料：均衡的通货膨胀率
均衡的通货膨胀率
【均衡的通货膨胀率】亦称“完全预期的通货膨胀率”。预期的通货膨胀率等于实际的通货膨胀率时的通货膨胀率。在这种情况下，通货膨胀率是稳定的，人们完全可以准确地预期未来的通货膨胀率。因此，这种通货膨胀只影响经济中的名义变量(例如，价格水平与名义利率)，而不影响经济中的实际变量(例如，实际国民收入与实际利率)。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条