1)  Random lasers
无序激光
2)  random laser
无序激光器
1.
Study on recurrent light scattering in random laser with coherent feedback;
相干反馈无序激光器循环光散射探讨
2.
Laser light from a handful of dust" ——the newly discoved random laser;
“一把尘埃出激光”——介绍一种新的无序激光
3)  disorder
无序
1.
From disorder to order——nonlinearity is the power for the order of system s structure;
从无序到有序——非线性是系统结构有序化的动力之源
2.
The localized properties of electronic states in one-dimensional disordered binary solid;
一维无序二元固体中电子局域性质的研究
3.
The effect of disorder on transmission spectra of two-dimensional photonic crystals with transfer matrix method(TMM) was investigated.
将转移矩阵法(Transfer Matrix Method)用于数值模拟无序情况下的二维光子晶体传输特性。
4)  random
无序
1.
Multiple Scattering in Random Laser with Coherent Feedback;
相干反馈无序激光器中的多重光散射
2.
The paper puts forward that there are two kinds of light localizations at same time in random laser with coherent feedback: the one is that the recurrent light scattering loop restricts photons in the loop,the another is that the scattering particles restrict photons in the entire gain medium,and on the base,it expatiates the work principle of the random laser with coherent feedback.
提出了相干反馈无序激光器中同时存在两种光局域化,第一种是循环光散射回路使光子局域于回路,第二种是无序介质中的散射粒子使光子局域于整个增益介质,并以此阐述了相干反馈无序激光器的工作原理。
3.
I/S minerals formed under different geological conditions contain different amount of illite layers when their transition occur from random to ordered interlayerings.
伊/蒙混层由无序到有序是一个连续的渐变过程,存在过渡型混层矿物,多数伊/蒙混层矿物都是以某一类型为主的复杂集合体。
5)  random aggregation
无序聚集
6)  disorder
无序度
1.
Results indicate that ZrO2 crystalline lattice with an increasing solid solubility exhibits larger disorder.
结果表明,Al2O3在ZrO2中的固溶度越大,ZrO2晶体结构无序度越大。
2.
The results indicate the band gap changes with the variation of structure parameter a and b,a wide band gap with relative band width (Δω/ω_0) of 68 % can be get by adjusting a and b,and its width changes lightly with the incident angle,influence of the disorder is small comparing with binary photonic crystals.
结果表明,其带隙宽度随结构参数a、b明显的改变;适当调节两个参数,得到了带隙相对宽度(Δω/ω0)为68%的带隙结构,带隙宽度几乎不随入射角的变化而改变,并且随实际操作中带来的随机误差引起的无序度的改变不明显,由此可方便地用于制作全角宽带反射镜等光学器件。
参考词条
补充资料:半导体激光泵浦的激光晶体


半导体激光泵浦的激光晶体
LD pumped laser crystal

  半导体激光泵浦的激光晶体LD PumPed lasercrystal适用于半导体二极管作泵浦源的激光晶体。传统的固体激光器一般用闪光灯泵浦,由于闪光灯的发光区域宽,只有一部分能量被吸收后转换成激光,大部分转换成热量,使工作物质温度上升,恶化了输出激光束的质量。半导体激光器输出的激光谱线窄(一般为几纳米),选择合适的半导体激光器,使其激光光谱与某种固体激光材料的吸收光谱匹配,即可达到高效泵浦,大大减轻固体工作物质的热负荷。 因为半导体激光器光泵区域小,需用的晶体尺寸也小,因此要求基质晶体内可掺入的激活离子浓度要高,且不产生浓度碎灭。此外,要求与光泵的半导体激光波长相匹配的晶体的吸收带要宽,吸收系数要大;要有低的阑值功率;Q开关运转时,荧光寿命要长。当泵浦光源从闪光灯改变为半导体激光二极管时,对被泵浦的激光晶体产生了不同的要求。用闪光灯泵浦时,对材料的热性能和机械性能有严格要求,而半导体泵浦则更注重材料的光谱性能。 在已使用的激光晶体中,掺钱石榴石(Nd:YAG)晶体的阑值功率低,光学质量高,是应用于半导体激光光泵的固体激光器的主要材料。由于Nd3+离子在基质晶体中受分凝系数的限制,Nd3+离子浓度不能太高,所以一些氟化物和钨、钥酸盐晶体等掺杂浓度高,激光效率高,荧光寿命长,有可能成为半导体激光泵浦的后选晶体。 用半导体泵浦可制成效率高、功率和频率稳定、激光束质量好、寿命长的全固化激光器,并经各种频率转换技术,可发展成各种波长、各种模式、各种运转方式的激光器,这种激光器将在很大范围内取代已有的各类固体、液体和气体激光器。 (沈鸿元)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。