1) control force bound
控制力有界
2) bounded controller
有界控制器
1.
The problem of robust exponential stabilization of a class of uncertain dynamic systems with multi time varying delays and bounded controllers is considered.
考虑了一类具有多重时变滞后和有界控制器的不确定动力系统的鲁棒指数稳定性问题 。
3) critical maximum control rolling force
临界控制轧制力
1.
Based on the VC roller developed,the roll gap profile and the relationship among crown of roll gap,rolling load and the control pressure were studied,and the concept of critical maximum control rolling force was put forward.
研究结果表明:当轧制力小于轧辊系统的最大临界控制轧制力时,其板形控制能力优于同规格的实心平辊;当控制压力较大且轧制力较小时,轧辊系统可以实现零凸度或负凸度的负载辊缝。
4) impulsive controllable boundedness
可脉冲控制有界
1.
Besides,the problem of impulsive controllable boundedness of differential equations was discussed in the paper too.
得到二阶脉冲微分方程的解有界或趋于零的充分条件,并讨论微分方程解的可脉冲控制有界问题,强调脉冲扰动对系统的解的有界性的影响。
5) energy constraint on control input
控制能量有界
1.
In the paper,the time-invariant linear-quadratic problem with energy constraint on control input is dealt with via a new approach.
本文通过新的途径讨论控制能量有界的时不变系统线性二次型最优控制问题。
6) bounded constrained control
有界约束控制
1.
This dissertation investigate mainly some controllability problems on bilinear control systems governed by second order parabolic type equations, control systems governed by four order semilinear Cahn- Hilliard type equations with traditionally additive distributed controls and semilinear second order parabolic control systems with bounded constrained controls.
本文主要研究了二阶抛物型方程支配的双线性控制系统，具有经典分布控制的四阶半线性Cahn-Hilliard型方程支配的控制系统和具有有界约束控制的半线性二阶抛物系统的能控性问题。
补充资料：控制离心力
用常规切削速度和转数使用可转位刀片是60年代之后铣削技术的新台阶。当前在高速切削领域除了整体硬质合金刀具外还有可转位刀具。优先使用的领域是铝合金加工和刀具、模具制造。
 |  |
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条