1) Acrylonitrile-butadiene rubber latex
丁腈乳液
2) Carboxylated acrylonitrile butadiene rubber latex
羧基丁腈乳液
3) butadiene-acrylonitrile latex
丁腈胶乳
1.
Study on butadiene-acrylonitrile latex wastewater treatment by activated carbon-microwave irradiation;
活性炭-微波辐照处理丁腈胶乳生产废水的研究
4) NBR emulsoid
丁腈乳胶
1.
It is put forward in this paper that a new technologic method to prepare the winding clutch friction materials by using water-based phenolic resin modified by NBR emulsoid as adhesive , glass fiber , core-spun yarn as the reinforcing fibers and the two new NBR composite filler as the main filler.
本文提出了以丁腈乳胶改性水基酚醛树脂作粘合剂,分别以玻璃纤维和复合包芯纱纤维作为增强材料,采用两种新型丁腈复合填料作主要填料制备高性能离合器摩擦材料的试验方法。
2.
It is proposed in this paper that a new technological method to prepare the winding clutch friction materials by using water-based phenolic resin modified by NBR emulsoid as adhesive,glass fiber,core-spun yarn as the reinforcing fibers and the two new NBR composite filler as the main filler.
本文提出采用丁腈乳胶改性酚醛树脂作粘结剂、采用玻璃纤维和复合包芯纱作为增强纤维、丁腈橡胶复合填料制备离合器摩擦材料的工艺方法。
5) emulsion styene-butadiene rubber
乳液丁苯
1.
The effects of monomer conversion on Mooney viscosity, conbined styrene content,molecular weight distrbution,microstructure and so on of emulsion styene-butadiene rubber were studied.
本文研究了单体转化率对乳液丁苯门尼粘度和特性粘度、凝胶含量、结合苯乙烯合量、玻璃化温度、胶乳稳定性、分子量及分布和微观结构的影响规律。
6) styrene-butadiene latex(SBL)
丁苯乳液
1.
Two different reinforced methods are introduced to intensify the interface so as to improve the microstructure and mechanical performance of fiber mortar,and these two methods are named silica fume(SF) reinforced and styrene-butadiene latex(SBL) reinforced.
采用硅灰增强和丁苯乳液增强2种方式对钢纤维-水泥基体界面过渡区进行增强,以改善钢纤维砂浆的微观结构和力学性能。
2.
The effect of styrene-butadiene latex(SBL) on the water absorption ratio and the carbonization depth of cement mortar were studied.
研究了丁苯乳液对水泥砂浆吸水率及碳化深度的影响,并提出了吸水率、碳化深度的多因素预测模型。
补充资料：丁腈乳液
丁腈乳液是由丙烯腈与丁二烯共聚而得，简称NBRL。平均分子量50～20万。根据结合丙烯腈量的不同。有高腈(45％)、中腈(33％)、低腈(25％)三个品级之分。随着丙烯腈含量的增加，极性增大，耐油、耐溶剂性改善，定伸强度、粘接性能提高，低温屈挠性降低。由于共聚物中含有腈基、放有良好的耐油性、耐化学药品性、耐热性、粘接性、耐磨性等，但高脂含量的丁腈乳液耐寒性、 电性能和耐水性较差。
用作水基胶粘剂或改性剂，是无纺布制造的较理想的胶粘剂。
用作水基胶粘剂或改性剂，是无纺布制造的较理想的胶粘剂。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条