1) casing process
浇铸方法
3) arranging PZT fibers and casting epoxy resin
排列-浇铸法
1.
1-3 piezoelectric composite which contains about 25 percent ceramic phase was prepared by arranging PZT fibers and casting epoxy resin.
采用排列-浇铸法制备了纤维体积分数为25%的1-3型压电纤维复合材料,计算了材料的介电常数、机电耦合系数和机械品质因数。
4) solution-casting method
溶液浇铸法
1.
Perfluorosulfonated membrane was prepared through solution-casting method from perfluorosulfonated resin, which was synthesized in lab via copolymerization of tetrafluoroethylene,hexafluoropropylene and perfluoro[2-(2-fluorosulfonylethoxy) propyl vinyl ether].
采用四氟乙烯、六氟丙烯和全氟磺酰基乙烯基醚共聚合成了全氟磺酸离子交换树脂,通过溶液浇铸法将其制成全氟磺酸离子交换膜(PSAIM)。
5) gel-casting
凝胶浇铸法
1.
Hydroxyapatite/polylactic-co-glycolic acid(HA/PLGA)composites are prepared by gel-casting.
采用凝胶浇铸法,将PLGA-HA凝胶与多孔HA中间层复合。
2.
Hydroxyapatite/poly lactic-co-glycolic acid(HA/PLGA)and PLGA-HA-TiO_2 composites were prepared by gel-casting and cold pressing-solidifying,respectively.
采用添加造孔剂法制备出骨组织工程用多孔羟基磷灰石(HA)中间层,研究了造孔剂种类、含量、温度等因素对孔径、孔隙率、力学性能的影响:应用凝胶浇铸法制备出HA-PLGA复合材料,研究了其制备工艺及其弹性模量:通过冷压与固化技术制备出HA-PLGA-TiO_2复合材料,评价了该复合材料的生物相容性。
6) solution casting method
溶液浇铸法
1.
MWNTs/HA composites were in situ synthesized by wet method with the help of ultrasonic, and PLA/MWNTs/HA composite membranes were prepared by solution casting method.
采用超声辅助原位湿法合成多壁碳纳米管/羟基磷灰石纳米复合材料(MWNTs/HA),并通过溶液浇铸法制备了PLA/MWNTs/HA复合材料薄膜。
补充资料：浇铸法(casting)
【浇铸法】(casting)塑料的成型方法之一。在不加压或稍加压的情况下，将液态单体、树脂或其混合物注入模内并使其成为制品的方法。例如，甲基丙烯酸甲酯或浇铸杨有机玻璃，环氧树脂经浇铸可得浇铸塑料。多用以制造板材、电绝缘材料或装饰品等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条