说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 上覆岩层净应力
1)  net overburden stress
上覆岩层净应力
2)  overburden stress
上覆岩层应力
3)  net overburden pressure
净上覆地层压力
1.
The core testing results show that porosity and permeability of reservoir rocks decrease with the increase of net overburden pressure, and the fluctuation range of permeability is more than that of porosity.
黄骅坳陷北部南堡凹陷高柳地区明化镇组、馆陶组砂岩属疏松、固结程度较差的储集层 ,岩心实验结果表明 ,随着净上覆地层压力 (净覆压 )的增加 ,岩石的孔隙度、渗透率均不同程度地降低 ,并且渗透率的变化幅度远大于孔隙度。
4)  overburden pressure
上覆岩层压力
1.
This paper introduces the method of determining overburden pressure by using density logging data.
介绍了利用密度测井资料求取上覆岩层压力梯度的方法和步骤,并提出了一种更合理的拟合方程对上覆岩层压力梯度曲线进行拟合,以期获得更加合理的外推数据。
2.
There are certain relations among overburden pressure,underlying fluid pressure and matrix stress,and different understandings of how to describe or depict them in the end.
上覆岩层压力与下伏岩层中的流体压力以及岩石骨架应力之间,存在着一定的关系。
5)  pseudo overburden pressure
视上覆岩层压力
1.
This paper aims at the question that the carbonate fonnation pressure is relatively difficult to predict, proposes estimating formation fracture pressure new method in carbonate profile by using pseudo overburden pressure method, discusses how to establish pseudo overburden pressure model in carbonate profile, and determine the parameter of model .
本文针对碳酸盐岩地层破裂压力预测相对较难这一问题,提出了一种利用视上覆岩层压力来估算地层自然破裂压力的新方法,重点讨论了在碳酸盐岩剖面中如何构建视上覆岩层压力模型,以及利用漏失测试资料和密度测井曲线确定模型参数的问題。
6)  overlying strata
上覆岩层
1.
Analysis on the mechanism of the face-contacted blocks structure in overlying strata above the longwall face;
采场上覆岩层面接触块体结构的力学机理分析
2.
Analysis on the damage zone of overlying strata and safety layer distance on the upward mining above the longwall goaf
长壁开采上覆岩层损伤范围及上行开采的层间距分析
3.
Based on the experiment with similar material,the laws of the extra subsidence on the surface and the stress vary inside overlying strata by newly increased load on the surface above worked-out area formed by fully mined and partial mined were researched.
通过相似材料模拟实验,研究了全部开采和部分开采条件下的采空区在地表新增荷载后,地表附加沉降和采空区上覆岩层内应力的变化规律。
补充资料:锅炉、压力容器、压力管道及特种设备定期检验


锅炉、压力容器、压力管道及特种设备定期检验
periodic inspection of boilers, pressure vessels, pressure piping and special equipment

  guolu YOli侧飞扣1 YOli gLJal对印ji tez陌叩劝以拍1 dingqi】,on四n锅炉、压力容器、压力管道及特种设备定期检验(peri诫c inspectionof城le。,p~切reves-Sels,p~二piPing ands衅过闪uiplr屺nt)为保证设备的安全使用,规定设备必须按一定周期进行法定的、强制性的检验。定期检验由政府设立的检验所、使用单位或行业检验站进行。检验单位及检验人员必须具有与所检设备相适应的资格。设备使用单位应该建立定期检验制度,做好检验计划,按时向检验单位提出申请。检验单位应该保证及时进行检验,检验按有关检验规则进行。检验时,设备使用单位应做好配合工作,提供必要的运行资料。检验完毕,检验单位要出具检验报告,对设备能否使用,要作出明确结论。如设备有缺陷,要提出是否修理、监护使用和报废的处理意见。锅炉压力容器安全监察机构根据检验机构的报告,发使用许可证书。有缺陷的,责令使用单位修理,修理后检验仍不符合安全要求的,则通知报废。使用单位逾期不进行定期检验,锅炉压力容器安全监察机构有权停止其设备运行。(陈亦惠)
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条