1) pool boiling
大容器沸腾，池沸腾;大容积沸腾;池塘沸腾;池内沸腾
2) pool boiling
池内沸腾
1.
In this paper an experimental investigation of pool boiling heat transfer at horizontal plate surface is conducted for 26 nm Fe-water and 13nm Al2O3-water nano-particle suspensions.
本文对纳米颗粒悬浮液在平壁面上池内沸腾进行了实验研究。
2.
In order to further confirm the feasibility to simulate complicated phase transitions with the present model,the simulation on pool boiling and boiling flow in a vertical pipe is conducted.
为进一步验证该模型模拟复杂相变问题的可行性,利用该模型对池内沸腾和垂直管道中的流动沸腾现象进行了模拟,观察到气泡随时间变化不断长大,气泡受浮升力的影响脱离壁面,以及气泡在液相中上升时发生碰撞、聚合等现象。
3.
Several fractal models for the nucleate pool boiling, subcooled flow boiling,CHF and nanofluids boiling heat transfer are reviewed,summarized and discussed.
简要评述了沸腾换热(池内沸腾、流动沸腾、临界热流密度和纳米流体沸腾换热)的研究进展;详细论述了采用分形理论和方法研究沸腾换热分析解的理论和方法;指出了采用分形理论和方法有可能解决其它尚未解决的有关沸腾换热的若干课题和方向。
4) pool boiling
池式沸腾
1.
Investigation of CaSO_4 scale formation under pool boiling;
池式沸腾条件下CaSO_4污垢生成的实验研究
2.
A new method was developed to obtain a new kind of enhanced surface for pool boiling heat transfer.
引 言核状池式沸腾是一种成核现象 ,它包括气泡的产生、气泡的生长以及气泡的脱离 3个阶段 。
3.
Fouling runs were carried out under pool boiling condition with heat fluxes of 100-300kWm-2 and a saturated CaSO4 concentration at 100 篊.
在池式沸腾装置中对CaSO4溶液的结垢过程进行了实验研究,并将离子注入表面的抗垢性能与未处理表面进行了比较。
5) pool boiling
池沸腾
1.
Bubble dynamics and heat transfer mechanism of pool boiling of R-113;
R-113池沸腾气泡行为的可视化及传热机理
2.
Experimental Investigation on the Pool Boiling Heat Transfer Characteristics of R123 outside Single Horizontal Tubes;
R123水平强化单管外池沸腾换热实验研究
3.
Experimental research on pool boiling heat transfer of water-lithium bromide solution at vacuum;
溴化锂水溶液在真空下池沸腾换热的实验研究
6) nucleate pool boiling
池核沸腾
1.
Investigation on Heat Transfer and Calcium Carbonate Scale Formation during Nucleate Pool Boiling;
池核沸腾传热与CaCO_3垢生成的研究
2.
Therefore, the nucleate pool boiling heat transfer coefficients of methanol have been tested for 9 JK-2 tubes, a JK-1 tube and a smooth tube.
测试了甲醇在９根第二代机械加工表面多孔管（ＪＫ－２管）、１根第一代机械加工表面多孔管（ＪＫ－１管）和１根光滑管上的单管饱和池核沸腾传热系数，结果表明，ＪＫ－２管比ＪＫ－１管能更有效地强化甲醇的池核沸腾传热。
3.
The nucleate pool boiling heat transfer coefficients of water on 9 JK-2 tubes, a JK-1 tube and a smooth tube were measured.
测试了水在9根第2代机械加工表面多孔管(JK-2管)、1根第1代机械加工表面多孔管(JK-1管)和1根光滑管上的单管饱和池核沸腾传热系数,结果表明,JK-2管比JK-1管能更有效地强化水的池核沸腾传热。
补充资料：池沸腾
分子式：
CAS号：
性质：指加热壁面被沉浸在无宏观流速的流体表面下所发生的沸腾。这时从加热表面产生的气泡能脱离表面自由浮升。池沸腾时，液体的运动只是由自然对流和气泡扰动引起。
CAS号：
性质：指加热壁面被沉浸在无宏观流速的流体表面下所发生的沸腾。这时从加热表面产生的气泡能脱离表面自由浮升。池沸腾时，液体的运动只是由自然对流和气泡扰动引起。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条