1) tensile and shear strength
抗拉剪切强度
1.
Experiment on tensile and shear strength of front fillet welded joint post-high-temperatures
高温后正面角焊缝抗拉剪切强度的试验
2) Anti tensile shearing strength
抗拉伸剪切强度
3) shear strength
抗剪切强度
1.
The effect of crystal powder on the shear strength and expansion ratio of the crystal powder/epoxy resin composite by different composition and technology was studied systematically.
对水晶粉/环氧树脂复合材料的抗剪切强度、热膨胀系数进行较系统的研究,并用扫描电镜(SEM)对水晶粉/环氧树脂复合材料断面显微结构进行了观察。
2.
Gauging the shear strength,tensile strength and modulus,glass transition temperature of the composite and their change during the aging test.
选用TDE-85和E-51作为主体树脂,制备了一种T700碳纤维复合材料,并对这种复合材料进行耐湿热老化研究,分别测定其抗剪切强度、抗拉伸强度及模量和玻璃化转变温度随老化时间的变化值。
3.
This paper briefly introduces the use of the cable bolt anchoring technology, initially analyzes the anchoring mechanism of the fully bonded cable bolt in the jointed rock mass, and examines some factors affecting the tensile bond strength and the shear strength of the cable bolt in the jointed rock mass.
简要介绍了锚索加固技术的应用，并对全长粘结式锚索在节理岩体中的锚固作用机理进行初步分析，同时对节理岩体中锚索加固的抗拉粘结强度及抗剪切强度的影响因素进行了分析。
4) shear bond strength
抗剪切强度
1.
Comparison on shear bond strength of edgewise brackets bonding with three orthodontic adhensives under different adhensive conditions;
3种正畸秞质粘接剂在不同粘接条件下的抗剪切强度比较
2.
Objective To observe the shear bond strength after different methods are adopted to deal with the enamel with fluoride.
方法挑选因正畸需要而拔除的96颗双尖牙,随机分为对照组、酸蚀前加氟组、酸蚀液中加氟组、酸蚀后加氟组,粘接托槽后进行冷热循环实验,测定并记录托槽抗剪切强度及黏接剂残留指数计分评估。
3.
Result:The shear bond strengths were negative relative to the roughnes.
各组处理后涂底涂剂,与硅橡胶粘结,测试其抗剪切强度,观察其破坏方式。
5) tensile shear strength
拉伸剪切强度
1.
MTS-810 testing apparatus and scanning electron microscope were used to study the tensile shear strength, elongation and microstructure of epoxy construction adhesive before and after the vacuum thermal cycling.
采用MTS-810型材料试验机和扫描电子显微镜,研究了真空热循环下环氧结构胶粘剂拉伸剪切强度、延伸率和微观结构等变化规律。
2.
In this paper,the influences of curing agent,low molecular polyamide,organophilic montmorillonite and nano-Al2O3 on tensile shear strength and erosion and wear resistance of epoxy resin coating were studied,the results showed that the tensile shear strength and the erosion and wear resistance of the coating can be improved obviously with organophilic montmorillonite and nano-Al2O3.
研究了固化剂低分子聚酰胺、有机蒙脱土和纳米Al2O3的用量对环氧树脂胶粘涂层拉伸剪切强度和耐冲蚀磨损性能的影响。
6) tensile strength
拉伸剪切强度
1.
Polyurethane adhesives prepared from liquefied wood has the tensile strength of 5 MPa,which meets the application requirement.
利用液化产物制备了聚氨酯胶黏剂,拉伸剪切强度达5 MPa,达到应用要求,为今后的工业化生产提供了依据。
2.
The influence of the ratio of monomers and photoinitiator on tensile strength was discussed.
本研究采用三种丙烯酸酯单体(M01、M02、M03)和一种紫外光引发剂(I01)配制了紫外光固化胶粘剂,探讨了不同原料配比对产品拉伸剪切强度的影响。
3.
The data of adhesion and tensile strength showed that the water-based CPP paint can substitute for solvent-based CPP coating.
从粘附力和拉伸剪切强度测定结果可以看出,用水性氯化聚丙烯代替溶剂型氯化聚丙烯是可行的。
补充资料：拉伸剪切粘接强度
分子式：
CAS号：
性质：对粘接头试片的胶层施加拉伸剪切负荷，至接头破坏的最大负荷，除以粘接面积的值。也即在平行于胶层的载荷作用下，胶接试样破坏时，单位胶接面所承受的剪切力，用MPa表示。胶黏剂的拉伸剪切强度试验还常在高温或低温条件下进行。是胶黏剂主要的胶接强度指标，许多国家都有标准试验方法。
CAS号：
性质：对粘接头试片的胶层施加拉伸剪切负荷，至接头破坏的最大负荷，除以粘接面积的值。也即在平行于胶层的载荷作用下，胶接试样破坏时，单位胶接面所承受的剪切力，用MPa表示。胶黏剂的拉伸剪切强度试验还常在高温或低温条件下进行。是胶黏剂主要的胶接强度指标，许多国家都有标准试验方法。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条