1) withdrawal rate
抽拉速率
1.
Effects of withdrawal rate on microstructure and mechanical property of single crystal superalloy SRR99;
抽拉速率对SRR99单晶高温合金组织和性能的影响
2.
Relationship between primary dendrite arm spacing of Al-4.5%Cu alloy and withdrawal rate during unidirectional solidification;
定向凝固Al-4.5%Cu合金枝晶组织与抽拉速率的关系
2) withdrawing rate
抽拉速率
1.
The effect of withdrawing rate on the solidification microstructure of a single crystal superalloy DD6 was investigated.
研究了不同的抽拉速率对第二代单晶高温合金DD6凝固组织的影响。
2.
The low cycle fatigue properties of second generation single crystal superalloy DD6 with different withdrawing rates at 760 ℃ were studied.
研究了不同的抽拉速率对第二代单晶高温合金DD6的760℃低周疲劳寿命的影响。
3) withdrawal rate
抽拉速度
1.
Effects of withdrawal rate on microsturcture of a nickel base single crystal superalloy were investigated.
研究了抽拉速度对一种镍基高温合金DD98凝固组织的影响。
2.
Directional solidification experiments were carried out on nickel based super-alloy DZ125 under withdrawal rates of 50 μm/s,50 μm/s and 100 μm/s in order to investigate the distribution and variation of the micro-porosity.
研究了不同抽拉速度下镍基高温合金DZ125定向凝固试样中显微缩松的分布、变化规律。
4) pumping speed
抽气速率
1.
Relationship between pumping speed of oil diffusion pump and gases pumped;
油扩散泵抽气速率与被抽气体的关系
2.
Analysis on pumping speed of roots pump unit;
罗茨真空泵机组抽气速率分析
5) pumping rate
抽运速率
1.
Taking Tm~(3+) ion as an example,relationship between the minimum energy gap and the laser pumping rate is analyzed,and the relationship between the energy gap and the cooling power as well as the relationship between the energy gap and the heat-light converting efficiency under the diff.
以Tm3+掺杂离子为例,从理论上分析了最小制冷能级间距与激光抽运速率的关系,研究了不同抽运速率下制冷功率与能级间距的关系以及热光转换效率与能级间距的关系,获得了最佳热光转换效率与抽运速率的关系,结果表明,最小的制冷能级间距约为4500 cm-1,能级间距在5000~6000 cm-1的宽度是比较合适的。
6) speed of evaporation
抽空速率
补充资料：抽抽趔趔
1.犹言别别扭扭。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条