1) Wind-heat in lung
风温肺热
2) wind-warm and pulmonary heat syndrome
风温肺热证
1.
Clinical study of wind-warm and pulmonary heat syndrome treated with integrated traditional Chinese and Western medicine;
中西医结合治疗风温肺热证临床观察
3) Wind-warm Lung-heat disease
风温肺热病
1.
ObjectivetTo observe the clinical curative effect of treating Heat-sydrome hi FeiWei of Wind-warm Lung-heat disease with QingFeiXiaoYanYin and antibiotic .
目的：观察清肺消炎饮合抗生素治疗风温肺热病热在肺卫证的临床疗效。
4) hot blast temperature
风温
1.
The hot blast temperature is higher and higher.
本钢热风炉用燃烧器由金属燃烧器到陶瓷燃烧器,由套筒式陶瓷燃烧器到矩型陶瓷燃烧器的应用过程,风温水平上了一个台阶。
2.
In this article, the present situation and technology features of preheating technology of using low caloric blast furnace to obtain high hot blast temperature,and the theoretical basis of preheating were summarily introduced.
本文概要介绍了利用低热值高炉煤气获取高风温技术的应用现状、技术特 点及预热的理论基础，探讨了理论燃烧温度的影响因素及程度，进而阐明推广利用低 热值高炉煤气获取高风温的预热技术对降低能源消耗、减少环境污染、提高风温皆具 有积极的现实意义。
3.
In April,1993,the average hot blast temperature used in BF reached 1014
该热风炉于1991年9月投产,1993年4月平均使用风温达1014℃。
5) blast temperature
风温
1.
In order to study the combustion characteristic of the waste plastic at blast temperature,the content of CO and CO2 of gas during the combustion course of polyethylene particle and the mixture of coal powder at the blast temperature was measured by the infrared analysis instrument,and then corresponding combustion rate was calculated.
为了研究废塑料在高炉风温条件下的燃烧特性,用红外分析仪测出聚乙烯(PE)颗粒和煤粉混合物在风温条件下燃烧时尾气中CO和CO2的含量,进而计算出不同条件下的燃烧率。
2.
Coal rate can be raised by using high quality burden,raising blast temperature,using oxygen combined with coal injection,strengthening blast furnace operation and improving pulverized coal combustion conditions.
通过精料、提高风温和富氧率、优化喷吹工艺、抓好高炉操作等技术措施,可以提高高炉煤比,从而降低焦比。
3.
1 BF along with the improving of beneficiated material level, such as raising blast temperature, using oxygen combined with coal injection, improving operation mode, strengthening equipment management, adopting advanced equipments, etc.
随着精料水平的提高,莱钢1#高炉通过提高风温、富氧大喷吹相结合,改进操作方式,加强设备管理,采用先进设备等措施,使入炉焦比从1998年的518kg/t降低到目前的360kg/t。
6) air temperature
风温
1.
The air temperature is improved above 950～1000℃.
经合理设计 ,热风炉各项指标达到了预期目标 ,风温提高到 95 0～ 10 0 0℃ ,满足了生产需求 ,而且具有投资省、见效快的特
2.
It is considered that, air speed,air temperature, air relative humidity and air pressure have influence upon unevenness of PET POY.
讨论了侧吹风的风速、风温、相对湿度及风道压力对涤纶POY条干不匀率的影响。
3.
A series of technical measures are taken at the blast furnace to increase the air temperature,such as using cold air that comes from the stove,distributing the fume in the stove reasonably,using of fume waste heat recovery technology,auto-matic combustion and enriched oxygen combustion technology.
对高炉采取了一系列技术措施来提高高炉风温,通过应用热风炉冷风和烟气的合理分配、烟气余热回收技术以及自动烧炉和富氧烧炉等技术,并对风温提高后的配套设施进行了改造,2007年厂高炉平均风温达1167℃,改善了高炉技术经济指标,节能降耗效果显著。
参考词条
补充资料：温肺
温肺 温肺 治疗学术语。又称温肺散寒。肺寒证的治疗方法。肺寒本属阳虚，阳虚生外寒，故多用辛温解表之剂温肺散寒，常用细辛、桂枝、麻黄、干姜、葱白之类。阳虚则阴盛，故肺寒多饮证，治宜温肺逐饮，常用小青龙汤、苓桂术甘汤等。又温肺常须结合补脾益肺，或温补命门以治其本。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。